Login or Register to Ask a Question and Join Our Community


Linux

Message from syslogd

Login to Discuss or Reply to this Discussion in Our Community

 
Thread Tools Search this Thread
Operating Systems Linux Message from syslogd
# 8  
Old 07-22-2006
$ dmesg | grep -i "irq.*17"
ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 18 (level, low) -> IRQ 17
saa7134[0]: found at 0000:00:0a.0, rev: 1, irq: 17, latency: 32, mmio: 0xe6001000
irq 17: nobody cared (try booting with the "irqpoll" option)
Disabling IRQ #17
# 9  
Old 07-23-2006
Hi,

Could you send me the output of the command --

# lspvi -v





--
Atul
# 10  
Old 07-23-2006
I haven't such command

# uname -a
Linux localhost.localdomain 2.6.16-1.2096_FC5 #1 Wed Apr 19 05:14:36 EDT 2006 i686 athlon i386 GNU/Linux
# 11  
Old 07-23-2006
I apologise for that but the command that I wanted to mention is ---

# lspci -v




--
ATUL
# 12  
Old 07-23-2006
Ok, here it is
Code:
# lspci -v
00:00.0 Host bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] (rev 03)
        Flags: bus master, medium devsel, latency 8
        Memory at e0000000 (32-bit, prefetchable) [size=64M]
        Capabilities: [a0] AGP version 2.0
        Capabilities: [c0] Power Management version 2

00:01.0 PCI bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133 AGP] (prog-if 00 [Normal decode])
        Flags: bus master, 66MHz, medium devsel, latency 0
        Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
        I/O behind bridge: 0000c000-0000cfff
        Memory behind bridge: e4000000-e5ffffff
        Prefetchable memory behind bridge: d0000000-dfffffff
        Capabilities: [80] Power Management version 2

00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 40)
        Subsystem: VIA Technologies, Inc. VT82C686/A PCI to ISA Bridge
        Flags: bus master, stepping, medium devsel, latency 0
        Capabilities: [c0] Power Management version 2

00:07.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP])
        Flags: bus master, medium devsel, latency 32
        I/O ports at d000 [size=16]
        Capabilities: [c0] Power Management version 2

00:07.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1a) (prog-if 00 [UHCI])
        Subsystem: VIA Technologies, Inc. (Wrong ID) USB Controller
        Flags: bus master, medium devsel, latency 32, IRQ 11
        I/O ports at d400 [size=32]
        Capabilities: [80] Power Management version 2

00:07.3 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 1a) (prog-if 00 [UHCI])
        Subsystem: VIA Technologies, Inc. (Wrong ID) USB Controller
        Flags: bus master, medium devsel, latency 32, IRQ 11
        I/O ports at d800 [size=32]
        Capabilities: [80] Power Management version 2

00:07.4 Host bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 40)
        Flags: medium devsel, IRQ 9
        Capabilities: [68] Power Management version 2

00:07.5 Multimedia audio controller: VIA Technologies, Inc. VT82C686 AC97 Audio Controller (rev 50)
        Subsystem: Micro-Star International Co., Ltd. Unknown device 3400
        Flags: medium devsel, IRQ 10
        I/O ports at dc00 [size=256]
        I/O ports at e000 [size=4]
        I/O ports at e400 [size=4]
        Capabilities: [c0] Power Management version 2

00:08.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
        Subsystem: Surecom Technology EP-320X-R
        Flags: bus master, medium devsel, latency 32, IRQ 16
        I/O ports at e800 [size=256]
        Memory at e6000000 (32-bit, non-prefetchable) [size=256]
        Capabilities: [50] Power Management version 2

00:0a.0 Multimedia controller: Philips Semiconductors SAA7134 Video Broadcast Decoder (rev 01)
        Subsystem: Compro Technology, Inc. Compro VideoMate Gold+ Pal
        Flags: bus master, medium devsel, latency 32, IRQ 17
        Memory at e6001000 (32-bit, non-prefetchable) [size=1K]
        Capabilities: [40] Power Management version 1

01:00.0 VGA compatible controller: ATI Technologies Inc RV350 AP [Radeon 9600] (prog-if 00 [VGA])
        Subsystem: PC Partner Limited Unknown device 0200
        Flags: bus master, 66MHz, medium devsel, latency 255, IRQ 16
        Memory at d0000000 (32-bit, prefetchable) [size=128M]
        I/O ports at c000 [size=256]
        Memory at e5000000 (32-bit, non-prefetchable) [size=64K]
        [virtual] Expansion ROM at e4000000 [disabled] [size=128K]
        Capabilities: [58] AGP version 2.0
        Capabilities: [50] Power Management version 2

01:00.1 Display controller: ATI Technologies Inc RV350 AP [Radeon 9600] (Secondary)
        Subsystem: PC Partner Limited Unknown device 0201
        Flags: bus master, 66MHz, medium devsel, latency 32
        Memory at d8000000 (32-bit, prefetchable) [size=128M]
        Memory at e5010000 (32-bit, non-prefetchable) [size=64K]
        Capabilities: [50] Power Management version 2

# 13  
Old 07-24-2006
Hi Hitori,

You can try adding the following to the /etc/grub.conf file -----

kernel /vmlinuz-2.4.20-8bigmem ro root=LABEL=/ irqpoll

See, if that helps you out and resolves this problem.





--
Atul
# 14  
Old 07-24-2006
The system doesn't boot at all with this option Smilie
Any other ideas Smilie Any help is appriciated
Login or Register to Ask a Question

Previous Thread | Next Thread

10 More Discussions You Might Find Interesting

1. Solaris

Syslogd configuration

Where do I configure where syslogd writes to log files? I've got open files in an archive directory called errlog.131017 and audlog.131017 and, having run an fuser, it appears that syslogd is writing to these files. (3 Replies)
Discussion started by: psychocandy
3 Replies

2. Solaris

Syslogd

Hi , Iam using Solaris8 and as I checked I found syslogd process not running can please somebody suggest me the way to start it. (2 Replies)
Discussion started by: Laxxi
2 Replies

3. AIX

Configure AIX syslogd

Hi Guys, I am configuring syslogd for Message broker. I know that we have to add a line user.* /var/log/wmb.log to the /etc/syslog.conf file. I want to know what userid does the user in user.* take? Thanks (1 Reply)
Discussion started by: vandi
1 Replies

4. Solaris

Restarting syslogd on Unix

Hi All, I can seem to find the syslog daemon in the /etc/init.d/ dir. i have made change to the syslog.conf i need to restart the daemon. am using solaris 10. i have no problem on version 9 Anyone with a template i can use for log review for auditing purposes. (1 Reply)
Discussion started by: lottiem
1 Replies

5. AIX

syslogd - unable to log ?

Hi, I wanted to log some authentication information, so I added following line to /etc/syslog.conf: auth.info /home/vilius/dir1/eeerrr.log After that I refreshed syslogd subsystem: refresh -s syslogd To check my logging I made few unsuccessfull attempts to login as root using ssh and... (1 Reply)
Discussion started by: vilius
1 Replies

6. Solaris

Ignore events with syslogd

Hi friends, is it possible to ignore special messages with syslogd? we have some errors that are firmware issues an no real faults. we serach for a way to ignore ONLY these messages... OS is solaris 10... any ideas? tia, DN2 (1 Reply)
Discussion started by: DukeNuke2
1 Replies

7. UNIX for Advanced & Expert Users

Syslogd

I have a remote syslog server which is recieving messages from many hosts. I would like it to log them in seperate files denoted by hostname . For example all messages for host1 in a directory of the same name. Is there an easy way to do this using syslogd? I have a feeling syslog-ng provides this... (3 Replies)
Discussion started by: silvaman
3 Replies

8. UNIX for Advanced & Expert Users

multiple instances of syslogd - is it possible?

I would like to start up multiple instances of syslog daemon. I am having a little difficulty. Is this at all possible? I have separate syslog.conf1.... syslog.conf5 files. I have linked the daemon to separate files syslogd1 ... syslogd5 I have arranged the rcd.2 start/stop scripts for... (9 Replies)
Discussion started by: Gary Dunn
9 Replies

9. Cybersecurity

HELP!!! syslogd is down...

Hi all My system logger has been down for the past 3 days... I am not able to get it to start from the terminal... /etc/init.d/syslogd start I am unable to find a log as to why it is failing!! Please advice where to look!!! I am totally lost here! Thanks in advance... KS (5 Replies)
Discussion started by: skotapal
5 Replies

10. UNIX for Dummies Questions & Answers

syslogd

Working out of AIX 4.3. All logs that were written via application suddenly stopped. executing a tail -f <logfile> was not producing any results. Tried to refresh the syslogd (daemon). When executing "refresh -s syslogd" system would display <<0513-036 The request could not be passed to... (2 Replies)
Discussion started by: buRst
2 Replies
Login or Register to Ask a Question