10 More Discussions You Might Find Interesting
1. Red Hat
Hi folks,
How to identify the SAN is running in Single path or dual source path for linux servers. (2 Replies)
Discussion started by: gsiva
2 Replies
2. Solaris
We have a Sun M5000 connecting to a Brocade SAN switch. I don't know the IP of the Brocade switch and don't want to use its serial port to get the info. How can I find the IP of the Brocade switch under Solaris 10? Snoop is not supported by Solaris multipathing. What other tools can I use to find... (6 Replies)
Discussion started by: aixlover
6 Replies
3. AIX
Can someone point me in the right direction as to where I can find information on how to cleanly disconnect my AIX 5.3 host from our DS/4200 SAN. I have to do a firmware upgrade on the SAN.
-Thanks (2 Replies)
Discussion started by: tfort73
2 Replies
4. AIX
How to find the status of SAN Disc through command prompt (1 Reply)
Discussion started by: AIXlearner
1 Replies
5. AIX
Hi,everyone
the situation is: at the very beginning ,through cfgmgr i find all LTO3 drives and 9840D drives. Then, some guy changed the device id(loop id) of all the stk drives on the tape lib panel. This time, i ran the cfgmgr but got nothing.
so i asked that guy to change the loop id... (2 Replies)
Discussion started by: zzisking
2 Replies
6. Filesystems, Disks and Memory
Hi All,
Storage team assigned same SAN disk on two servers
how to create same paritations from same SAN disk on two linux servers
may i know options & procedure. But here one server writing on SAN disk and another server reading other files from SAN disks
Thanks in advance (1 Reply)
Discussion started by: kurva
1 Replies
7. Filesystems, Disks and Memory
Am trying to differentiate between the local disks and LUN's presented from SAN onto the server. Have Tried fdisk -l, however I quite cudn't differentiate the local disks from SAN presented LUN's.
Can you pls. let me know the procedure and commands to find this.
OS - RHEL 4
SAN - EMC... (3 Replies)
Discussion started by: Crazy_murli
3 Replies
8. Linux
Hello everyone.
I was wondering if there is a way to increase the size on the LUN on a SAN and make the Linux kernel understand the changes without restarting?
In the past it has always been rebooted to see the new values but im sure that there is a way now for the lvm to see the Free PE in... (8 Replies)
Discussion started by: d_ark
8 Replies
9. Filesystems, Disks and Memory
I'm setting up a CentOS 5 server that will be connected to an HP EVA4000. My previous experience is with an HP VA7400 and HP-UX. In HP-UX I can add "alternate paths" to a volume group in order to have redundant paths to the SAN via dual fiber channel HBAs just by either adding them with... (3 Replies)
Discussion started by: deckard
3 Replies
10. Solaris
Hi everyone,
I wonder if I can canvas any opinions or thoughts (good or bad) on SAN attaching a SUN V880/490 to an EMC Clarion SAN?
At the moment the 880 is using 12 internal FC-AL disks as a db server and seems to be doing a pretty good job. It is not I/O, CPU or Memory constrained and the... (2 Replies)
Discussion started by: si_linux
2 Replies