I use DHCP on my AIX box at home . I want to connect to my Cable ISP as a
DHCP Client . the thing I did was this :
after that I edit /etc/resolv.conf it look like this
The DHCP Server serve me with a IP adress and I can connect via ftp, telnet
ect.
BUT : If I start the CDE and login, the following message appear :
Could not start DT Message System .......
After pushing the ok Button the system goes back to de CDE login.
What did I wrong or forget ? Is there any guru outside who can give a
beginner a little finger
I try a static ip assign mode while i installed the Solaris 10(U 8). But i can't access the internet, i try the ifconfig -a command and see my configuration is correct in the interface. So i want to get my ip using dhcp. I search from internet. They give me the suggestions.
ifconfig interface... (1 Reply)
The following thread is closed: 133552-howto-linux-multihomed-dns-client (Sorry I am not allowed to post URLs)
Therefore I write this append in an own thread.
The HOWTO in the referenced thread helped me a lot and I only want to append how to make reverse lookup working for a local zone:
... (0 Replies)
The Linux resolver queries all nameservers in the order they are listed in /etc/resolver.conf.
If a nameserver times out, it advances on to the following nameserver.
But, if a nameserver returns "not found" (NXDOMAIN) it stops.
This behaviour is problematic when you need to resolve names from... (0 Replies)
:b:Hi...
I need help to configure nim client on nim server..
can i define aix 5.3.4.0 on aix 5.3.7.0 nim server.. while i m configuring nim client on nim server its getting msg that images not same.. i need to confirm that both version should be same or not..
Thanks.. (5 Replies)
Hi All,
i have been accessing ip address through DHCP for my windows..i tried to configure the same for solaris also and got the error " Failed to configure IPv4 for DHCP afe0 "
can anyone explain what should i do ...i want to acees internet in solaris
am i need to configure for... (0 Replies)
I am pretty new to this. My router was earlier configured to enable DHCP, thus my UNIX box is using the dhcp address, i.e. I have to do a ifconfig dhcp hme0 start. Since I am planning to use my NT as a web server, I needed to use the static IP address. How do I configure the unix box to use the... (5 Replies)
I have openserver 5.0.7 running on a machine and would like to know how to configure a dhcp client for it and make it run at startup.
Thank you. (1 Reply)