IP Networking

Hi gurus of unix, I haved installed my openSolaris in a HP530,
Recently I use the following command
beadm destry opensolaris1
beadm destry opensolaris2
After That I reboot my Laptop.
Well when I go to my work I try to open my wireshark tool, but the option in GUI interface does not appear!!!
To run the Wireshark I put the following command:
andres@opensolaris:~$ export PATH=/usr/gnu/bin:/usr/bin:/usr/X11/bin:/usr/sbin:/sbin:/usr/local/bin:/usr/perl5/bin
andres@opensolaris:~$ wireshark
After That, I put the command wireshark
I Observe the folling messages after put wireshark command
dumpcap: There are no interfaces on which a capture can be done
dumpcap: There are no interfaces on which a capture can be done
dumpcap: There are no interfaces on which a capture can be done
dumpcap: There are no interfaces on which a capture can be done
dumpcap: There are no interfaces on which a capture can be done
dumpcap: There are no interfaces on which a capture can be done
dumpcap: There are no interfaces on which a capture can be done
dumpcap: There are no interfaces on which a capture can be done
I have the following interfaces:
andres@opensolaris:~$ dladm show-link
LINK CLASS MTU STATE OVER
iprb0 phys 1500 down --
wpi0 phys 1500 up --
vboxnet0 phys 1500 unknown --
andres@opensolaris:~$ dladm show-phys
LINK MEDIA STATE SPEED DUPLEX DEVICE
iprb0 Ethernet down 0 half iprb0
wpi0 WiFi up 11 unknown wpi0
vboxnet0 Ethernet unknown 0 unknown vboxnet0
andres@opensolaris:~$ ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
iprb0: flags=1000802<BROADCAST,MULTICAST,IPv4> mtu 1500 index 2
inet 0.0.0.0 netmask 0
wpi0: flags=1004843<UP,BROADCAST,RUNNING,MULTICAST,DHCP,IPv4> mtu 1500 index 3
inet 192.168.1.33 netmask ffffff00 broadcast 192.168.1.255
vboxnet0: flags=1000842<BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 4
inet 0.0.0.0 netmask 0
lo0: flags=2002000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv6,VIRTUAL> mtu 8252 index 1
inet6 ::1/128
wpi0: flags=2004841<UP,RUNNING,MULTICAST,DHCP,IPv6> mtu 1500 index 3
inet6 fe80::21c:bfff:fe4c:6c95/10
andres@opensolaris:~$
Any guru That can show me how to aggragete these interfaces in My wireshark Tool, please

You need to have sufficient permissions to capture network traffic. Depending on the release you are running, one of these commands should work:

Code:

pfexec wireshark
sudo wireshark
su root -c wireshark

Thanks jlliagre!!!!

I run pfexec wireshark and I can see the Option Interfaces!!!
(the version of the wireshark That I Have is 1.4.3)