Hi need to add 2 routes, one on each server.
I know the route add comand but I have always been given the parameters to put in.
I need a route in each of the 2 following servers to be able to ping and ssh between them. But how do i know which netmask to put in the route add command ?
In server4 i would like to use interface ce0
in server3 i would like to use interface ce1
I would apreciate very much if some one could explain how to do it
beacuse it`s a mystery to me.
Also the actual route add comand would be apreciated since im running out of time.
Below is actual config that does not permit ping between servers.
server4
server3
Thanks to every one that takes time to respond.
/Jan
hi,
not an expert in Solaris networking so would like to ask your opinions
Say i want to configure packet routing from source 10.126.120.130 (A) to destination 10.214.140.9 (B).
I configured it this way (shown in netstat -rn) on (B)
Destination Gateway Interface... (7 Replies)
I am trying to capture the ipv6 packets through pcap utility.
For that i am redirecting the ipv6 packets to the loopback address , but the ipv6 packets are not getting redirected to tha loopback address.Instead they are taking there normal routes. (1 Reply)
I have a Windows laptop and a Sparc desktop. I'm trying to toy around with routing.
If have always on broadband from BT. My router ipaddress is:
192.168.1.1
This router uses DHCP.
My Laptop Ip is as follows:
Ethernet adapter Local Area Connection:
Connection-specific DNS... (1 Reply)
I am using RedHat Linux 9, In this box their are two lan intefaces.
eth0 ====> LAN
192.168.100.100
255.255.255.0
eth1 ====> Internet
Static IP
255.255.255.0
59.144.168.226 (Gateway)
I want to define a gateway 59.144.168.226 for my LAN... (2 Replies)
Hello Friends
I have two network cards
eth0 192.168.100.1
eth1 10.0.0.1
There NIC connect with diff. LAN
I want to make my Linux machine as a Router, Please tell me
using
IPTABLES command
ROUTE command
:) (2 Replies)
Can anyone help with the following;
I am working on a unix server (Apple OS X Server). We have two network cards in the server. Both cards are on different subnets i.e en1 is on 192.168.10.10/24 and the built in ethernet is on 10.10.150.10/24. From a computer plugged into en1 (and set to ip... (5 Replies)
ok i configured my gateway and IP address(es) using ifconfig and route.. but how can i bind unique IPs to users ? (im using FreeBSD 4.2 RELEASE #3) (9 Replies)
I have SCO Unix. I have 2 routers. as it is now, when someone telnets to UNIX and goes through router #1 everything is fine. The users who go through router #2 can not connect at all. I talked to CISCO and they said I need to set up a second Gateway on UNIX. They said what is happening is that... (1 Reply)