Dear friends
I use RedHat 6.5, which sets the gateway in the configuration file / etc / sysconfig / network as GATEWAY = 192.168.1.26, and the gateway in the configuration file / etc / sysconfig / network-scripts / ifcfg-eth11 as GATEWAY = 192.168.1.256. The two gateways are different.... (6 Replies)
Dear Sir
I am a newbie in the world of IP telephony. I have been working with Asterisk PBX (SIP) and Cisco Call Manager (MGCP) but now I am learning on how to work GNUGK for H.323 Gatekeeper.
I am having a problem, configuring static call routing on GNUGK
in the section
... (0 Replies)
I set up remote printing on a clients Unix server to my Windows XP USB printer. My USB printer is connected directly to my PC (no print server and no network input on printer). With my Win XP PC connected to my cable modem (without the router), i can do
lp -dhp842c /etc/hosts and it prints. I... (7 Replies)
amttool(1) General Commands Manual amttool(1)NAME
amttool - remotely control Intel AMT managed machines.
SYNOPSIS
amttool host [ command ] [ arg(s) ]
DESCRIPTION
amttool is a perl script which speaks SOAP to Intel AMT managed machines. It can query informations about the machine in question and also
send some commands for basic remote control.
host is the hostname or IP address of the machine amttool should control. command is an optional command.
You must set fill AMT_PASSWORD environment variable with the AMT password.
For more inforamtions on Intel AMT check amt-howto(7).
COMMANDS
info gather information (default).
reset [ special ]
reset machine, with optional special command (see section below).
powerup [ special ]
turn on machine.
powerdown
turn off machine.
powercycle [ special ]
powercycle machine.
netinfo
print network configuration (requires AMT 2.5+).
netconf if link [ ip mask gw [ dns1 [ dns2 ]]]
configure network interface (requires AMT 2.5+). if is the interface handle, link the link policy. If in doubt just feed in what
the netinfo command prints. ip is the IPv4 address, mask the netmask, gw the default gateway, dns1 and dns2 are the DNS Servers.
If no IP configuration is specified the tool tries to configure the machine in shared mac address mode with dhcp, otherwise in sepa-
rate mac address mode with static IP address. Default for dns1 is the gateway address, for dns2 it is 0.0.0.0.
SPECIAL COMMANDS
Special commands can optionally be specified for reset, powerup and powercycle. They change the default boot behavior of the machine.
bios Asks for the BIOS boot messages being redirected to serial-over-lan.
pxe Network boot via PXE.
hd Boot from local disk.
hdsafe Boot from local disk (safe mode).
cd Boot from CD/DVD.
diag Boot in diagnostics mode.
ENVIRONMENT
AMT_PASSWORD
AMT password.
AMT_DEBUG
Enable debug output.
SEE ALSO amtterm(1), gamt(1), amt-howto(7)AUTHOR
(c) 2007 Gerd Hoffmann <kraxel@redhat.com>
(c) 2007,08 Gerd Hoffmann amttool(1)