10 More Discussions You Might Find Interesting
1. UNIX for Beginners Questions & Answers
I need to update a setting in the BIOS on our SCO Openserver 5.0.7 system and all I can bring up about it says I need to create a dos bootable disk of some sort. The problem is that it doesn't seem like dos is loading up fully. I created the dos bootable thumb drive on a Windows PC using Rufus... (7 Replies)
Discussion started by: hometrics
7 Replies
2. Ubuntu
I have a problem with a brand new Dell laptop. BioLinux was installed on it without making the necessary changes on BIOS. The installation was completed successfully but the BIOS system cant find the OS after rebooting the machine.
I have tried to modify the BIOS setting with no luck this far. I... (7 Replies)
Discussion started by: Xterra
7 Replies
3. Debian
okay,i made a grave mistake in installing the base bare bones install of debian.
here i have edited this from the original.
this morning when i got home from work i did some searching and then just shut the system down via the mechanical off on switch. waited a few minutes and then restarted... (0 Replies)
Discussion started by: cowLips
0 Replies
4. IP Networking
Hello
I am communicating with two devices using my computer over UDP protocol. The application is running fine. When I monitored the UDP traffic using Wireshark software, I found that there were too many Checksum errors.
Please find attached the png file showing this error. I am about to... (0 Replies)
Discussion started by: AustinCann
0 Replies
5. Hardware
Hi friends,
I hope you are doing well. Can you please tell me which part of the motherboard contains the BIOS software, name that exact location. And could please give me the names of the firmwares for atleast 5 archetictures, like sun sparc, ibm power, hp alpha etc.
Looking forward to your... (0 Replies)
Discussion started by: gabam
0 Replies
6. Shell Programming and Scripting
Why I get bad replace when using eval?
$ map0=( "0" "0000" "0")
$ i=0
$ eval echo \${map$i}
0000
$ a=`eval echo \${map$i}` !!!error happens!!!
bash: ${map$i}: bad substitution
How to resolve it ?
Thanks! (5 Replies)
Discussion started by: 915086731
5 Replies
7. SCO
I'm on SCO 5.07. Just installed mini tape. Getting CMOS/GPNV checksum error when I turn on the machine and have to go into bios. I just hit f10 and I continue. When loading SCO and it get to the mini tape I get Warning: SCSI boot options ignored: Bad paremeter count. It's a QIC 80.
When in bios if... (2 Replies)
Discussion started by: Mike Gomes
2 Replies
8. Solaris
Hello,
I'm brand new to Sun/Solaris.
I have a Sun Blade 150, with SunOS 5.8.
I wanted to make a backup to prevent future data loss, so I put the disk in a normal PC with Windows XP to try to make a backup with Norton Ghost, the disk was detected, but not the file volume, so I place the disk... (6 Replies)
Discussion started by: Resadija
6 Replies
9. Solaris
I am using solaris 10
how to get the bios version?
thanks (4 Replies)
Discussion started by: melanie_pfefer
4 Replies
10. Windows & DOS: Issues & Discussions
Does anyone know a good driver site. If you've heard of driverguide.com or driversearch.com please do not reccomend them because I already know them. I need to know where to get Motherboard drivers for a homemade computer. If there is any info that you need to know feel free to make a reply.
:) (5 Replies)
Discussion started by: computek
5 Replies