10 More Discussions You Might Find Interesting
1. Hardware
Hi i ahve a SCSI drive that it use to work but now is not working. The Sun machine can not read the drive. My question is there is any other way to get the data back from the SCSI drive? I think if i replace the chip board on teh SCSI drive it might help to just buy a new Board but there is any... (4 Replies)
Discussion started by: percel
4 Replies
2. Hardware
I've had a scsi hard drive, scsi tape drive, and cd rom working off an adaptec 29160 controller. Everything worked great until a few days ago. I begin getting tar format errors (running sco 5.0.6) on the tape drive and occasionally the entire system would hang up while trying to access data on... (0 Replies)
Discussion started by: powwm
0 Replies
3. Solaris
Hi, i'm trying to install a MO Disk Drive Sony model: SMO-f541, to read a 2.6gb Magneto Optical Disk, I install Solaris 10 in a x86 machine with these specifications:
Desktop Board Intel*D946GZIS
Intel core 2 duo 4300, 80ghz
Ram 2038
hard disk 250 gb
I have a PCI SCSI card AHA-2940UW,
At the... (0 Replies)
Discussion started by: Jevivre
0 Replies
4. SCO
Hello,
I'm having some issues with installing SCSI tape drive on SCO 5.0.6
hardware config shows the following adapters
%adapter 0xE800-0xE8FF 10 - type=alad ha=0 bus=0 id=7 fts=sto
%adapter 0x0170-0x0177 15 - type=IDE ctlr=secondary dvr=wd
%adapter - 3 - ... (3 Replies)
Discussion started by: ananth_ak
3 Replies
5. Filesystems, Disks and Memory
Hi
I have 2 75GB SCSI hard drives and 2 250GB SATA hard drives which are using RAID Level 1 respectively. I wana have both FTP and Apache installed on them as services. I'm wondering what's the best partitioning schem? I wana use FC3 as my OS, so, I thought I can use the 75GB hard drive as the /... (0 Replies)
Discussion started by: sirbijan
0 Replies
6. Filesystems, Disks and Memory
DG Aviion (intel h/w) R4.20MU04
I plugged two new drives into my SCSI array, and need instructions on how to configure the filesystems...I've worked on Solaris (on Sun HW) boxes in the past, never has the pleasure of doing it on a DG.
1) Must I reboot for the system to "see" the drives? When... (0 Replies)
Discussion started by: iwasbornin1970
0 Replies
7. Filesystems, Disks and Memory
We are still using solaris 1 with sunos 4.1.4 because nobody here knows Unix.
My colleague did a backup (dump) to the wrong place (/dev/sd0h) and we lost this part of the drive. The information is still on tape but we cannot repartition the /dev/sd0h. fsck keeps on about the "wrong SUPER BLOCK"... (2 Replies)
Discussion started by: Tom Bekaert
2 Replies
8. Filesystems, Disks and Memory
Need to change the partitions on a SCSI drive with Nextstep.
df shows
filesystem kbytes used avail cap mounted on
/dev/sd0a 2051824 231924 13% /
/dev/sd0b 998332 9 0% /Vol2
/dev/sd0c 998332 9 0% /Vol3
/dev/sd0d 998332 9 0% /Vol4
/dev/sd0e 998332 9 0% /Vol5... (3 Replies)
Discussion started by: Mace
3 Replies
9. UNIX for Dummies Questions & Answers
Adding another scsi drive, no name, it came with the instruction manual in japanese, so of no use. We need to format it, it only shows up as 14 gigs, when we know it is a 40 gig drive, but have no specs on the cyl, etc. Combing through faqs, one of my coworkers found a blurb that unix won't... (1 Reply)
Discussion started by: kymberm
1 Replies
10. UNIX for Dummies Questions & Answers
I'm running SCO OS 505 on a Compaq proliant 1600, and my tape drive will just not work. It was working properly and whent to Sh?ts when I tried to get the cd rom working. I have uninstalled any configured tape drive and rebooted and then configured a tape drive and rebooted still nothing. I'm... (4 Replies)
Discussion started by: kikkin
4 Replies
