9 More Discussions You Might Find Interesting
1. UNIX for Beginners Questions & Answers
Hello Forum,
I'm making very good progress on my report thanks to the very helpful people on this forum. I've been able to successfully create my report for my Red Hat servers. But I do have a few ubuntu servers in the mix and I'd like to capture some data from them when an ssh connection is... (8 Replies)
Discussion started by: greavette
8 Replies
2. AIX
Folks,
Again a very silly question :D Could someone tell me, how to determine the power family(540, 520, 575, 595 etc) just by looking into the model # info from prtconf/lsconf o/p of the lpar?
I dont want run a search on any search engine to find out the power family or hit IBM website to... (3 Replies)
Discussion started by: thisissouvik
3 Replies
3. AIX
Hello,
I keep getting this message even after i removed it from the cron enteries it was added automatically
Broadcast message from root@oradb (tty) at 12:00:00 ...
rc.powerfail:2::WARNING!!! The system is now operating with a power problem. This message will be walled every 12... (2 Replies)
Discussion started by: filosophizer
2 Replies
4. UNIX for Dummies Questions & Answers
Hi Friends
I have 2 solaris boxes and I need to check certain directories (on local filesystem and mounted nfs) to make sure that they match up on both boxes and to delete or move the other mismatches to elsewhere on the local filesystem.
I investigated for unix commands like rsync, and tree... (1 Reply)
Discussion started by: mpc8250
1 Replies
5. AIX
Hello Everybody, we have a
System Model: IBM,7017-S7A running AIX 4.3
Processor Type: PowerPC_RS64-II
Number Of Processors: 4
I found while running "diag" the following errors.
The Service Request Number(s)/Probable Cause(s)
(causes are listed in descending order of... (3 Replies)
Discussion started by: karthikosu
3 Replies
6. Solaris
hi guys,
i'm new so don't bite too hard.
having a problem booting up a V210 running sol9 on after a power outage...
an init5 was done but not a init0 before the power cut... so now when booting up it gives the ff:
SC Alert: Host System has Reset
Probing system devices
Probing memory... (2 Replies)
Discussion started by: lungsta
2 Replies
7. AIX
I ran 'diag' command to verify disk follow the below steps.
DIAG------?task selection-------ssa service aid-----Link verification
I found that there are 3 types of status. (Good, Failed and Power).
scp2: pdisk23 D69E584F 0 16 Power
scp2: pdisk19 D657E7A9 1 15 Power
scp2: pdisk28... (1 Reply)
Discussion started by: pattarapongn
1 Replies
8. AIX
I have 2 UNIX boxes and I need to determine whether or not they possess the same tape drive. What is the hardware command to determine what type of tape drive is present? Thx in advance. (4 Replies)
Discussion started by: Surdeymon
4 Replies
9. HP-UX
if user diag is removed with a -r will it delete usr/mds ? and if so will this prevent a system from booting?
Any info would be greatly appreciated!!
Thanks
Brian (1 Reply)
Discussion started by: breigner
1 Replies