Setting up HACMP 6.1 on a two node cluster. The other node works fine and can start properly on STABLE state (VGs varied, FS mounted, Service IP aliased). However, the other node is always stuck on ST_JOINING state. Its taking forever and you can't stop the cluster as well or recover from script failure. I can't see any error from hacmp.out.
Here's the latest error I see from clstrmgr.debug (This is from console so I just type it here
---------- Post updated at 03:52 AM ---------- Previous update was at 03:47 AM ----------
Also one thing to add is that, I can start the cluster on any node as long as I have not started any other node. Meaning I can start the cluster and RG on either node1 and node2 but If I start it on node1, node2 won't bring up by clstart and shows as ST_JOINING forever. Thus, I cannot do a failover to other node unless the other node is in stable state.
Last edited by Scrutinizer; 06-08-2013 at 06:22 AM..
Reason: code tags
Not sure about the reason without further information, but to me this looks like a communication problem. Check all the cluster networks (see "cllsif") for connectivity and mak sure the disk-heartbeat works as expected.
Another possible reason which comes to mind is the VG: make sure it is varied on in "enhanced concurrent" mode. Maybe there are disk reservations left over somehow: issue a "varyonvg -b -u" to break disk reservations.
Hi,
Is it possible to have a Solaris cluster of 2 nodes at SITE-A using SVM and creating metaset using say 2 LUNs (on SAN). Then replicating these 2 LUNs to remote site SITE-B via storage based replication and then using these LUNs by importing them as a metaset on a server at SITE-B which is... (0 Replies)
How can we add a shared zfs dataset between 2 zones on a same host. I have sun cluster 3.2 installed in a server which has 2 zones. I want to share a zfs data set between these 2 zones how can we do that ? (7 Replies)
Hi Gurus,
I am very new to clustering and for test i have created a single node cluster, now i want to remove the system from cluster. Did some googling however as a newbee in cluster unable to co related the info.
Please help
Thanks (1 Reply)
Hi Gurus,
For learning purpose, I have installed a single node cluster 3.2 on Solaris 10 for practice. Now I am welling to create two non-global zone and create them as a fail over. Will appreciate your help and assistance.
Thanks (3 Replies)
hi,
i am trying to setup a 2 node cluster environment. following is what i have;
1. 2 x sun ultra60 - 450MHz procs, 1GB RAM, 9GB HDD, solaris 10
2. 2 x HBA cards
3. 2 x Connection leads to connect ultra60 with D1000
4. 1 x D1000 storage box.
5. 3 x 9GB HDD + 2 x 36GB HDD
first of all,... (1 Reply)
Hi,
Please advise me whereas I have two node cluster server configured with MC/SG. Application and DB are running on Node 1, while Node 2 is standby.
All the volume group devices are part of cluster environment. There is only one package running at node 1.
Node 2 is having the problem to... (1 Reply)
Hello,
Under ksh I have to run a script on one of the nodes of a Solaris 8 cluster which at some time must execute a command on the alternate node:
# rsh <name> "command"
I have to implement this script on all the clusters of my company (a lot of...).
Fortunately, the names of the two nodes... (11 Replies)