Hello AIX GURU's
I try to remove Virtual Scsi from vio2 but it shows the following error:
the adapter is removed from VIO using the following command:
and in VIO profile there is no any definition about the virtual scsi adapter.. it exists only in
Dinamic Logigal partitioning sub menu .... I suppose there is some problem with RMC or HMC or Hypervisor .... P.S. on VIO1 everything works just perfect
---------- Post updated 03-24-12 at 07:50 AM ---------- Previous update was 03-23-12 at 02:29 PM ----------
Well I solved the above problem by shutting down VIO and starting again... rebooting VIO did't help because while rebooting it's doesn't read Nvram therefore VIO still was thinking that it still had Virtaual adapters added as required :-)
Hi,
We had a hardware problem with an IBM System p5 server, with AIX 5.2
We restore from a tape the last backup we had, but the server does not boot up as expected.
The server try to mount some directories from a storage, but could not comunicate with them, we check the FC and everything is... (12 Replies)
Hi
In the vio server when I do # lsattr -El hdisk*, I get a PVID. The same PVID is also seen when I put the lspv command on the vio client partition. This way Im able to confirm the lun using the PVID.
Similarly how does the vio client partition gets the virtual ethernet scsi client adapter... (1 Reply)
HI,
I use red hat linux ES 5.
I start the virt-manager and add new guest host in it .
But When I choose parXXX-virtuXXXXX ...not full-virtXXXx...
I get below screen to fill
installtion source
Please indicate where installation media is available
for the operating system you would like to... (1 Reply)
Hi,
I want to know wheather partition size for installation of vio client can be specified on vio server
example
If I am installing vio server on blade with 2*300gb hard disk,after that I want to create 2 vio client (AIX Operating system) wheather I can specify hard disk size while... (1 Reply)