I would like to know how to share lun in between 2 lpars.
I have run tbe below command on vio server.
after above command I am able to assign lun on one Lpar. but it is not visible to other lpar.
even after this I have run the command
on lpar on which it was visible.
wheather any other configuration needs to be done.
Moderator's Comments:
Please use code tags! You have 169 posts and still not able or too lazy to use them? Come on...
Last edited by zaxxon; 12-07-2011 at 03:36 AM..
Reason: code tags, see PM
There is another way you can create shared fcs as ehternet on VIO. Then your each lpar will have a fcs card and a wwn number, just mapp the wwn nuber of both laprs to the same lun on san and create a concurrent lv.
We are using Solaris 11 Logical Domains. We NFS share a disk backup area from one LDom to other servers. The share is on a single 1.5 Tb LUN presented to the Control Domain, and as a virtual disk on the NFS server LDom. A 1.5 Tb zpool has been created on the LDom. We now need to provide more disk... (2 Replies)
There can be configurations in IBM Server wherein a
standalone partition is created on some supported IBM Server
Or
A VIOS - VIOC LPARs created.
Now in both cases they are lpars. But if I want to differentiate b/w a standalone LPAR vs an VIOC LPAR how can I do..?
On a... (2 Replies)
We have a 2 node oracle rac cluster one node is in frame 1 and other is in frame 2
Now,because of some hardware failure(processor card and cable) in frame 1 we will failover database services from lpar in frame 1 to lpar(oracle rac cluster node2) in frame2 and the entire replacement of hardware... (9 Replies)
Hi all,
I have the following configuration
2 ds3524 storage disk systems located over 2 locations
2 P720 server located over 2 locations
DS3524 are connected to san switch.
Each vio server has 1 fc adapter attached to a san switch.
per p720 server 2 virtual io servers. Vio 1 has 1 lun... (2 Replies)
I have created a new LPAR using IVM.
I activated the LPAR, and start the window terminal (java), it prompt me for the padmin password.
After keyin the password, it will shows BOOTP parameter.
I am just wondering how come it didnt go to screen where i can select to go into SMS menu to pick... (0 Replies)
I am planning for System P with 2 number of 2-core processor (4 core in total).
Can I make 3 LPARS with this processor configuration without the support of micropartitioning, that means with simple LPAR only. (3 Replies)
I have a list of LUN ID, my task is to find if disk has been added or not. How do I do that? I have been searching the forum and not able to find answer.
thanks (4 Replies)
Hello guys,
It would be so nice of you if someone can provide me with these informations.
1) My SAN group assigned 51G of LUN space to the VIO server.I ran cfgdev to discover the newly added LUN. Unfortunately most of the disks that are in VIO server is 51G. How would I know which is the newly... (3 Replies)
I have RedHat 9.0 installed on three of my servers (PIII - 233MHz) and want that they share a common IP address so that any request made reaches each of the servers.
Can anyone suggest how should I setup my LAN. I'm new to networking in Linux so please elaborate and would be thankful for a timely... (2 Replies)