9 More Discussions You Might Find Interesting
1. UNIX for Dummies Questions & Answers
Hi Everyone,
I've been using awk '!x++' to get rid of redundancy in a file, but it's getting rid of some extra lines I need (like the plus signs in the example below).
So how would I go from this:
@XYZ
ABCD
345345
+
@MNO
EFGH
789789
+
@XYZ
ABCD
345345
+
to: (2 Replies)
Discussion started by: sp24
2 Replies
2. AIX
Hi
In the vio server when I do # lsattr -El hdisk*, I get a PVID. The same PVID is also seen when I put the lspv command on the vio client partition. This way Im able to confirm the lun using the PVID.
Similarly how does the vio client partition gets the virtual ethernet scsi client adapter... (1 Reply)
Discussion started by: newtoaixos
1 Replies
3. AIX
I have one p5 server, no lpar, 2 physical network adapter, bundle as one EtherChannel. The two 2 physical network adapter connect to 2 network switches.
How to make this as a redundancy config?
Current is if one physical network adapter down, the seond one will go through the network. but if... (2 Replies)
Discussion started by: rainbow_bean
2 Replies
4. AIX
Have been learning a lot off late and am a little unclear about the VIOS setup particularly with regards to redundancy. Would appreciate your help.
My question is very basic. Lets say I have setup a VIOS and 3 LPARs on only one hdd (non scsi). On what do I setup the second VIOS? Could I for... (7 Replies)
Discussion started by: theaixeman
7 Replies
5. AIX
Hi,
I want to know wheather partition size for installation of vio client can be specified on vio server
example
If I am installing vio server on blade with 2*300gb hard disk,after that I want to create 2 vio client (AIX Operating system) wheather I can specify hard disk size while... (1 Reply)
Discussion started by: manoj.solaris
1 Replies
6. UNIX for Dummies Questions & Answers
We have had some email outages in the last few months and my boss is asking is it worth going with one of those email redundancy/filtering sites. The thing is, we have a backup server on a remote location, so I am pretty sure we can set something up with what we have already.
At the moment... (1 Reply)
Discussion started by: edzillion
1 Replies
7. UNIX for Advanced & Expert Users
Here we want to implement the network redundancy on UNIX with the software.
The two network interface cards are configured on the UNIX node,once one card is down or unnormal,the other can take over. Those aplications that used the tcp ,udp,multicast protocol can also been switched at the same... (2 Replies)
Discussion started by: Frank2004
2 Replies
8. UNIX for Advanced & Expert Users
Dears,
I have server has two port's(Enet0,Enet1) what I want as follows:
Make the two port's has same IP address
where, if the port Enet0 became down automaticly Enet1 become up :confused: .
Amen (4 Replies)
Discussion started by: amen00
4 Replies
9. UNIX for Advanced & Expert Users
I'm trying to come up with an "imaging" type solution (a.k.a. Norton Ghost, Imagecast) with standard unix utils. I'd like to just image one of our FreeBSD servers so I can use the hot swap HD's. If one fails, I could slide in an exact duplicate HD and the server would be back up. I've tried just... (4 Replies)
Discussion started by: mstevenson
4 Replies