[...]In the command , lsattr -E -l inet0 I guess inet0 stands for Ethernet
How to know , which ethernet is our system using.
Is inet0 , a default for any production server ( I mean the server on which the applications are running) or can there be something like inet1 or inet2 etc
In that case how to find the ethernet address.[...]
The inet0 device contains (among other) information about the systems hostname and its default route. However, to find out about the server's TCP/IP address(es) you need to look up the configuration of the "en" devices. Use
to find out how TCP/IP is configured on your system. Then use
and/or
to see the device configuration information stored in the ODM. For a start these commands should return the information you are looking for.
Hi all,
actually i'm facing this problem,
we have 2 NICs on our VM.s with REDHAT 7.2 release,
we made the following set up as we needed to access them from both IP
ip route flush all
ip route add 10.130.11.0/24 dev eno2 tab 1
ip route add 10.130.10.0/24 dev eno1 tab 2
ip route add... (0 Replies)
Hi All
Recently we have faced issue in SUN server
after reboot of node 2 default routs has been added to system as below
IRE Table: IPv4
**Destination*************Mask***********Gateway**********Device Mxfrg Rtt***Ref Flg**Out**In/Fwd*
-------------------- ---------------... (2 Replies)
AIX version 5.3
when I try to add default gateway
# route add 0 192.168.100.254
Or
# route add default 192.168.100.254
I get the error
0821-275 route: socket: The file access permissions do not allow the specified action.
searching on google i came across similar... (5 Replies)
Greetings,
I am using debian squeeze to perform the following operation:
1. pxeboot Alix 2.c board into debian installer
When I get to the installer my laptop's dhcp server successfully provides an ip address but does not set up the default route. I am not sure how to provide this.
I... (2 Replies)
Hiya,
I got the default gateway set in /etc/defaultrouter file, however "netstat -nr" doesn't show anything like "default" in the routing table. As far as I know "netstat" on Solaris 10 u7 should show something like :
Routing Table: IPv4
Destination Gateway Flags Ref ... (8 Replies)
Hi,
I am new to solaris 10. What is the procedure the os takes if a default route is not configured? I am using a multihomed server with 4 interfaces. It looked strange to me this morning, because i had not defined a default route it defaulted to making one up, with the ip address of another... (9 Replies)
Hi,
We are running AIX 5.2.
Our default gateway used to be IP Address A.
Our new default gateway is IP Address B.
A netstat revealed that our default route was IP address A.
We manually added default route with IP address B and removed the default route with IP address A.
However,... (3 Replies)