Quote:
Originally Posted by
garethr
How about set up a "getty" process to listen on it and present a login prompt?
Put something like this in /etc/inittab, then "telinit q":
tty1:23:respawn:/usr/sbin/getty /dev/tty1
tty2:23:respawn:/usr/sbin/getty /dev/tty2
---------- Post updated at 10:49 ---------- Previous update was at 10:48 ----------
Then, of course, use a serial console to see whether you can see a login prompt.
If i put the lines in inittab file what do i have to do now shall i connect serial cable from AIX to the PC and configure hyperterminal?
---------- Post updated at 12:02 PM ---------- Previous update was at 11:24 AM ----------
I tried to configure modem according to the following document but the following error occured
The output of slattach connand is as follows.
what is the solution
# slattach tty1 38400 '"" ATZ OK ""'
strload: cannot load /usr/lib/drivers/slip: Cannot run a file that does not have a valid format.
slattach: 0821-300 ifconfig command must be run for this tty before slattach can be run.
# slattach tty1
strload: cannot load /usr/lib/drivers/slip: Cannot run a file that does not have a valid format.
slattach: 0821-300 ifconfig command must be run for this tty before slattach can be run.