9 More Discussions You Might Find Interesting
1. Forum Support Area for Unregistered Users & Account Problems
Hi...
I got my account created and after activation I'm not able to create new posts or start a new thread. Can you help on how to start a new thread?
Thanks. (1 Reply)
Discussion started by: Bang3095
1 Replies
2. AIX
Hello,
I installed PowerVM IVM Virtual I/O on P-550 but later found out that the machine isn't activated for CoD VET code for virtualization.
So when booted , it goes into OPEN Firmware
I/O Hosting requires a hosting partition boot not permitted exit called
> ok
Panel shows > IO... (3 Replies)
Discussion started by: filosophizer
3 Replies
3. Forum Support Area for Unregistered Users & Account Problems
Hi,
I've been waiting for about 2 hours to receive my activation email but it hasn't arrived yet. I followed the 'resend activation information' link so I'm now expecting 2 activation emails, neither has arrived yet. How long do I expect this to take?
I've tested my email account from other... (2 Replies)
Discussion started by: cambridge
2 Replies
4. Forum Support Area for Unregistered Users & Account Problems
Hi neo
I registered yesterday,but i don't receive the activation email,can u send again?
thanks! (1 Reply)
Discussion started by: swrd
1 Replies
5. Forum Support Area for Unregistered Users & Account Problems
Hi,
I have registered your site and i havent received any activation mail.
please send me activation mail.
Thanks & Regards,
BVIJAY (1 Reply)
Discussion started by: bvijaycom
1 Replies
6. Forum Support Area for Unregistered Users & Account Problems
can't activate (0 Replies)
Discussion started by: jamalwil7
0 Replies
7. Shell Programming and Scripting
Hi All,
I have set a cronjob to run a script at a frequency of 10 mins.
However, if the script takes more than 10 mins to complete, how will the cronjob behaves?
1) Does it ignore the current process and restart the whole process again?
2) Or does it stop to trigger the script again unless... (5 Replies)
Discussion started by: Raynon
5 Replies
8. Forum Support Area for Unregistered Users & Account Problems
Hi,
I got the username and activation code to my email id but when i click on the forum link and enter the activation code and username there then , It displays
"We could not activate your account because this web address is not valid. Make sure that you have the entire address from the... (1 Reply)
Discussion started by: MIKU
1 Replies
9. UNIX for Advanced & Expert Users
hello !
i am trying to activate my wireless network card on my laptop currently running :
2.6.18-1.2869.fc6 , but an error msg appears "ipw2200 device eth1 does not seem to be present, delaying initialization." the same msg also appears at the start up process, when trying to bring up eth1.
... (4 Replies)
Discussion started by: XinU*
4 Replies