Sponsored Content
Full Discussion: dhcp with solaris 8
Special Forums IP Networking dhcp with solaris 8 Post 7836 by mhunting on Tuesday 2nd of October 2001 03:00:26 PM
Old 10-02-2001
ok I have an Ultra 5.
now here is the strange thing. I have run infconfig -a and yes hme0 does show up but no ip is assinged to it and it is not up. i have to manually ifconfig hme0 up to get that working. but then after that I don't know what to do. I tried to set up my gateway with route add default <address> this would be the gateway address I was assinged from my cable company. make any sense?
 

10 More Discussions You Might Find Interesting

1. IP Networking

Solaris DHCP and DNS

I have managed to setup my Solaris box to receive an IP number from a DHCP server. In addition, I can ping and telnet between my dhcp server and my solaris box using the IP number. However, I can't resolve addresses by name from my solaris box. In my nsswitch.conf file I have: hosts: dns ... (4 Replies)
Discussion started by: marist89
4 Replies

2. Solaris

Solaris 10 u1 x86 DHCP

How is it possible to derive the very next IP that the solaris dhcp server is going to assign to the next host that requests? (0 Replies)
Discussion started by: ne0phyte
0 Replies

3. Solaris

Stop DHCP in Solaris 10

Can any one tell me how to stop DHCP service on Solaris 10 so that it should not start nextime when the system is rebooted. (2 Replies)
Discussion started by: shabu
2 Replies

4. Solaris

Setting DHCP on Solaris 8

I am trying to set up a DHCP on Sunblade 100. I have Dlink router that connects me to the net with my other computers. I can't seem to let my DHCP server to give out IP addresses instead of my router. I have been working on this for the last three days. I had an issue with Unknown name but i have... (4 Replies)
Discussion started by: aliban83
4 Replies

5. UNIX for Dummies Questions & Answers

Solaris Machine IP Configuration via DHCP

I have a new solaris machine and I am trying to bring the same on network. The IP assignemnt is via DHCP. I want to know as which files need to be modified to include DHCP server IP in order that the machine gets its IP via DHCP server. Thanks in Advance. :) (1 Reply)
Discussion started by: Ashvin Gaur
1 Replies

6. Solaris

Solaris 9 : DHCP Option 43 and 60

Hello, I need to configure a Cisco VLAN Accesspoint with DHCP using Solaris dhtadm & pntadm Network: 10.10.122.0 255.255.255.0 Default Router 10.10.122.1 Scope Range 10.10.122.10 - 254 Option 60 “Cisco AP c1142” Option 43 ... (0 Replies)
Discussion started by: fredy82
0 Replies

7. Solaris

Solaris 10 DHCP Help

Dear All, I have following configuration solaris 10 host interface e1000g0 hold IP 10.124.73.178 having internet access natted to public ip on cisco switch interface e1000g1 hold IP 192.168.8.10 DHCP server with DHCP client IP ranges 192.168.8.11 to 192.168.8.15 /etc/defaultrouter hold... (4 Replies)
Discussion started by: patel1678
4 Replies

8. Solaris

Solaris DHCP Server

I need to find out the MAC address of an IP leased from DHCP server . For Eg:-i need to know the MAC of the below mentioned IP at the below mentioned time . IP : 172.16.28.90 Date :Sunday July 2nd 2011 Time : 14.07.2011 OS -Solaris 10 Vital QIP IP management software using to... (0 Replies)
Discussion started by: sandeep.tk
0 Replies

9. Solaris

Dhcp in use or not on Solaris machine

Hi All, Could you please let me know how can we check whether any given solaris machien is using DHCP or not. is ps -ef | grep dhcp is full proof method or is their any other way. (10 Replies)
Discussion started by: omkar.jadhav
10 Replies

10. Solaris

Solaris static IP changed (non DHCP)

We have 2 solaris 10 t5240 servers with static IP addresses on nxge0 I/F which were rebooted a few days back with a known good config that has been in place for years (for /etc/hosts, /etc/hostname.nxge0, /etc/netmasks, etc) They are not using dhcp. About the same time today, both of their... (7 Replies)
Discussion started by: hdatontodo
7 Replies
VDE_L3(1)						      General Commands Manual							 VDE_L3(1)

NAME
vde_l3 - Virtual Distributed Ethernet 'Layer 3' Switch. SYNOPSIS
vde_l3 -v vde_plug:ipaddress/netmask [-v...] [-r target_network/netmask:gateway] [-G default_gw] [-M mgmt_socket] DESCRIPTION
A vde_l3 connects to one or more vde_switches, performing ip forwarding among its virtual interfaces. A new interface is created at startup for each -v option given at command line. Static routes to target networks can be defined using the -r option. vde_l3 -v /var/run/s1.ctl:192.168.0.1/24 connects to the vde sock at /var/run/s1.ctl with its virtual interface ve0, having the address 192.168.0.1 and netmask 255.255.255.0. vde_l3 -v /var/run/s1.ctl:192.168.0.1/24 -v /var/run/s2.ctl:10.0.0.254/255.255.0.0 connects to the two vde socks, with its virtual interfaces ve0 and ve1, having addressess 192.168.1.0 and 10.0.0.254 respectively. Hosts in each network can specify the vde_l3 as their gateway to reach the other one. OPTIONS
-v vde_plug:ipaddress/netmask Creates a virtual network interfaces on the vde_l3 box, with address ipaddress and netmask netmask. Please note that the netmask can be specified either in the 'classic' A.B.C.D mode, or just by giving the number of leading bits (f.e., /17 for 255.255.128.0). One can define as many interfaces as she wants. -r target_network/netmask:gateway Specify a static route through gateway to reach hosts in target_network with netmask netmask. One can define as many routes as she wants. -G default_gw Specify a default gateway, to be used whenever no static route is defined for a target host. -M mgmt_socket the unix socket where the parameters (interfaces addresses, routes, etc.) can be checked and changed runtime. unixterm(1) can be used as a remote terminal for wirefilter. NOTICE
Virtual Distributed Ethernet is not related in any way with www.vde.com ("Verband der Elektrotechnik, Elektronik und Informationstechnik" i.e. the German "Association for Electrical, Electronic & Information Technologies"). SEE ALSO
vde_switch(1), vdeq(1), unixterm(1), vde_cryptcab(1), wirefilter(1). AUTHORS
VDE_L3 is a tool by Daniele Lacamera <root@danielinux.net> VDE is a project by Renzo Davoli <renzo@cs.unibo.it> Virtual Distributed Ethernet May 7, 2007 VDE_L3(1)
All times are GMT -4. The time now is 03:47 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy