1. UNIX for Dummies Questions & Answers

Hi, I am trying to configure an ip address, netmask, and default gateway on my solaris machine. For example, in Linux I would do the following command: #ifconfig eth0 xx.xx.xx.xx netmask 255.0.0.0 #add route or route add default xxx.xxx.xxx.xxx In Solaris 10, I believe the commands are... (7 Replies)

2. Solaris

Solaris Guru's What is the proper way to add routes in the routing table so after a node reboot the routes will not be lost. I understand the /etc/defaultrouter for the default router and the <route add> command but using this command routes will be removed once the node reboots. Thanks (7 Replies)

3. Solaris

Hello All, I have a requirement to add multiple virtual interfaces on a non-global zone (Solaris 10). The global zone is a 2 node Veritas Cluster Server. So, my question is do we have to make any modifications to the cluster config (which I think should not be the case)? Can anyone help with me... (11 Replies)

4. Solaris

is it possible to add a user twice to solaris server with the same id? i have been added twice in the past week and that is messing up one application that i am using which authenticate against the os. (10 Replies)

5. Solaris

Hello, I have a machine with Solaris 8, and it has multiple interfaces that are connected to the same network which means they all have metric 0 (1 hop) to the default gateway. assume: * e1000g0: 10.1.1.70 * e1000g2: 10.1.1.72 * e1000g4: 10.1.1.74 * e1000g5: 10.1.1.76 * gateway:... (11 Replies)

6. Solaris

Hi Al, In course of understanding networking in Solaris, I have these doubts on Interfaces. Please clarify me. I have done fair research in this site and others but could not be clarified. 1. In the "ifconfig -a" command, I see many interfaces and their configurations. But I see many... (1 Reply)

7. UNIX for Dummies Questions & Answers

Just wanted to understand what is the logic being used by Solaris(kernel) to transmit data/traffic on physical interfaces. I have seen most of the time traffic is being sent to interface ce0 and sometime to ce1. I have removed ip address from below command for some reason. netstat -rn ... (3 Replies)