I stumbled accross this forum and was pleased by the very fair benchmark suite. I ran on my cheap desktop replacement laptop.. luckily I wasn't too penalized by disk tests for having a 5400RPM HDD. Not too shabby for a laptop.
CPU/Speed: Pentium 4b 2.4GHz w/ 512kb L2 - 4771 bogomips
Ram: 386MB... (0 Replies)
Anyone have tips on configuring the 2.6.10 kernel to take full advantage of dual 2.4 Ghz Xeons?
I'm not getting expected benchmark results.... and seemingly was better off with a single 2600+ AMD processor. (1 Reply)
Interesting issue. There was some discussion on the LKML last year regarding the potential problems in concurrent applications reusing file descriptors in various scenarios. The main issue is that the reuse of a file descriptor and reception of data in a threaded application can be confused pretty... (1 Reply)
I want to setup dual monitor for the Dell Optiplex Gx520 computer.
The motherboard has an Intel Corporation 82915G Integrated Graphics
Controller.
Then I add an ATI Rage 128 video card.
The dual monitor work on Windows 2000 with the Intel chip as the
primary screen and the ATI chip... (0 Replies)
I want to set-up Solaris on my Intel PC for training purposes. Ideally, I'd like to run Solaris within an emulator or in a dual-boot partition. Can anyone give me some suggestions to send me in the right direction? Thanks so much.
---------- Post updated at 09:11 PM ---------- Previous update... (1 Reply)
Discussion started by: ediverson
1 Replies
LEARN ABOUT MOJAVE
volcheck
volcheck(1) User Commands volcheck(1)NAME
volcheck - checks for media in a drive and by default checks all floppy media
SYNOPSIS
volcheck [-v] [-i secs] [-t secs] pathname
DESCRIPTION
The volcheck utility tells Volume Management to look at each dev/pathname in sequence and determine if new media has been inserted in the
drive.
The default action is to volcheck all checkable media managed by volume management.
OPTIONS
The following options are supported:
-i secs Set the frequency of device checking to secs seconds. The default is 2 seconds. The minimum frequency is 1 second.
-t secs Check the named device(s) for the next secs seconds. The maximum number of seconds allowed is 28800, which is 8 hours. The fre-
quency of checking is specified by -i. There is no default total time.
-v Verbose.
OPERANDS
The following operands are supported:
pathname The path name of a media device.
EXAMPLES
Example 1: A sample of the volcheck command.
The following example
example% volcheck -v /dev/diskette
/dev/diskette has media
asks Volume Management to examine the floppy drive for new media.
The following example
example% volcheck -i 2 -t 600 /dev/diskette1 &
asks Volume Management if there is a floppy in the floppy drive every 2 seconds for 600 seconds (10 minutes).
FILES
/dev/volctl Volume Management control port
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
+-----------------------------+-----------------------------+
| ATTRIBUTE TYPE | ATTRIBUTE VALUE |
+-----------------------------+-----------------------------+
|Availability |SUNWvolu |
+-----------------------------+-----------------------------+
SEE ALSO eject(1), volcancel(1), volmissing(1)rmmount(1M), vold(1M), rmmount.conf(4), vold.conf(4), attributes(5), volfs(7FS)WARNINGS
Due to a hardware limitation in many floppy drives, the act of checking for media causes mechanical action in the floppy drive. Continu-
ous polling of the floppy drive will cause the drive to wear out. It is recommended that polling the drive only be performed during periods
of high use.
SunOS 5.10 21 Feb 1997 volcheck(1)