04-03-2004
We have had this problem on a few of our L-class boxes. HP came out and replaced the card which resolved the problem. The only recommendation I can give you if you can't get support from HP is to shutdown the system, completely power it off and unplug it for a few minutes, maybe reset the GSP card, then power it back on.
If you go into SAM, under the performance section there is a system properties page which I believe will tell you what class the box is.
6 More Discussions You Might Find Interesting
1. AIX
I dont have an ascii terminal to hook upto this thing, trying to use my laptop but it doesnt seem to want to communicate, is there a special cable i should be using for this? (1 Reply)
Discussion started by: BG_JrAdmin
1 Replies
2. AIX
Question is on setting of Physical and Virtual processors for LPARs to make proper use of virtualization capabilities.
Environment is a 8-way p570 with 4 LPARs.
lparVIO1 and lparVIO2:
AIX 5300-04-01
Mode/Type= Shared-SMT/Capped
Minimum Processors= 0.10
Desired Processors= 0.50
Maximum... (1 Reply)
Discussion started by: guttew
1 Replies
3. AIX
Hi Folks,
I am a new AIX user. This is my first post in the UNIX forums. I did do a little bit of search before creating this post, but did not find any conclusive information. I am trying to connect to the service processor of an older 44p Model 170 box using my laptop. The 44p box has two... (6 Replies)
Discussion started by: shaell
6 Replies
4. AIX
Guys...
Hows it going???
I have been going through the hardware spec of IBM system p systems.. and here i am confused
for IBM Power 520 Express it says
Processor cores:
One, two or four 64-bit 4.2 GHz POWER6 with AltiVec™ SIMD and Hardware Decimal Floating-Point acceleration
... (1 Reply)
Discussion started by: balaji_prk
1 Replies
5. AIX
picked up this old p520 , try many ways to connect to the SP..
a) null modem using a PC connecting to the lower S1 ...but see a bunch of
garbages across the screen once the main machine is off
b) try guessing the default IPs 192.168.3.147 and 192.168.2.147, for ports HMC1 and HMC2
no... (7 Replies)
Discussion started by: ppchu99
7 Replies
6. Solaris
Hello,
I have an unloaded T5140 machine and want to access the ILOM for the first time and subsequently the network port after that., and then load Solaris 10 the final January 2011 build.
The first part is what confuses me -the cabling.
I am coming from a Windows machine (w/appropriate... (5 Replies)
Discussion started by: joboy
5 Replies