LOCKF(1)						    BSD General Commands Manual 						  LOCKF(1)

NAME

     lockf -- execute a command while holding a file lock

SYNOPSIS

     lockf [-kns] [-t seconds] file command [arguments]

DESCRIPTION

     The lockf utility acquires an exclusive lock on a file, creating it if necessary, and removing the file on exit unless explicitly told not
     to.  While holding the lock, it executes a command with optional arguments.  After the command completes, lockf releases the lock, and
     removes the file unless the -k option is specified.  BSD-style locking is used, as described in flock(2); the mere existence of the file is
     not considered to constitute a lock.

     If the lockf utility is being used to facilitate concurrency between a number of processes, it is recommended that the -k option be used.
     This will guarantee lock ordering, as well as implement a performance enhanced algorithm which minimizes CPU load associated with concurrent
     unlink, drop and re-acquire activity.  It should be noted that if the -k option is not used, then no guarantees around lock ordering can be
     made.

     The following options are supported:

     -k 	 Causes the lock file to be kept (not removed) after the command completes.

     -s 	 Causes lockf to operate silently.  Failure to acquire the lock is indicated only in the exit status.

     -n 	 Causes lockf to fail if the specified lock file does not exist. If -n is not specified, lockf will create file if necessary.

     -t seconds  Specifies a timeout for waiting for the lock.	By default, lockf waits indefinitely to acquire the lock.  If a timeout is speci-
		 fied with this option, lockf will wait at most the given number of seconds before giving up.  A timeout of 0 may be given, in
		 which case lockf will fail unless it can acquire the lock immediately.  When a lock times out, command is not executed.

     In no event will lockf break a lock that is held by another process.

EXIT STATUS

     If lockf successfully acquires the lock, it returns the exit status produced by command.  Otherwise, it returns one of the exit codes defined
     in sysexits(3), as follows:

     EX_TEMPFAIL   The specified lock file was already locked by another process.

     EX_CANTCREAT  The lockf utility was unable to create the lock file, e.g., because of insufficient access privileges.

     EX_UNAVAILABLE
		   The -n option is specified and the specified lock file does not exist.

     EX_USAGE	   There was an error on the lockf command line.

     EX_OSERR	   A system call (e.g., fork(2)) failed unexpectedly.

     EX_SOFTWARE   The command did not exit normally, but may have been signaled or stopped.

SEE ALSO

     flock(2), sysexits(3)

HISTORY

     A lockf utility first appeared in FreeBSD 2.2.

AUTHORS

     John Polstra <jdp@polstra.com>

BSD
								   July 7, 1998 							       BSD