rc3(8)							      System Manager's Manual							    rc3(8)

NAME

       rc3 - Run command script executed when entering a multiuser run level

SYNOPSIS

       rc3

DESCRIPTION

       The  rc3  script contains run commands that enable initialization of the system to a multiuser state; run level 3.  In addition to commands
       listed within the script itself, rc3 contains instructions to run certain commands found in the /sbin/rc3.d directory.  The script  defines
       the conditions under which the commands execute; some commands run if the system is booting, other commands execute if the system is chang-
       ing run levels.

       By convention, files in the rc3.d directory begin with either the letter "S" or the letter "K" and are followed by a two-digit number and a
       filename; for example: S00inet	  S55inetd     S70mount     S65lpd

       In  general,  the  system  starts commands that begin with the letter "S" and stops commands that begin with the letter "K."  Commands that
       begin with the letter "K" run only when the system is changing run levels from a higher to a lower level.  Commands  that  begin  with  the
       letter "S" run in all cases.  The numbering of commands in the /sbin/rc3.d directory is important since the numbers are sorted and the com-
       mands are run in ascending order.  Files in the /sbin/rc3.d directory are normally links to files in the /etc/init.d directory.

       An entry in the inittab file causes the system to execute the rc3 run commands, for example: s3:3:wait:/sbin/rc3 < /dev/console > /dev/con-
       sole 2>&1

       The  following operations are typical of those that result from executing the rc3 script and the commands located in the /sbin/rc3.d direc-
       tory.  The operation depends on which state the system is entering or exiting.  Setting the time zone Checking the current run level Start-
       ing network services and daemons Starting (or stopping) system services and daemons Mounting file systems

       Setting	the  TIMEZONE variable is one of the first operations completed by the rc3 script.  This action provides the default time zone for
       subsequent commands.

FILES

       Specifies the command path Specifies the directory of commands that correspond to the run level

RELATED INFORMATION

       Commands:  init(8), rc0(8), rc2(8) delim off

																	    rc3(8)