ok, I configured inetd.conf so that the tftp string
is not commented out, but I cannot get the process to start.
I'm running Solaris 5.8 and need some help.
Cabletron said that it's process is 3485, i tried to kill it, it's the wrong process. I started inetd again and still can't kill it.
i... (15 Replies)
Hello,
we practise our server with operating system ReliantUNIX 5.45 and we are using Informix Dynamic Server 7.31.
I ascertained a lot of cpu interrupts per second (int/s). The count of int/s exceeds critical maximum value considerably.
Machine specific notes for Informix Dynamic Server... (1 Reply)
Double question here ... Running on Debian Etch and Apache 2.0
1) Using mod_proxy and/or mod_proxy_http in apache 2.0.
The basics of using mod_proxy are pretty simple so long as you're using a static config. I'm trying to figure out how to do it dynamically - that is, allow the entry of a... (4 Replies)
Hello Dear Everyone.
Have you Gurus perhaps got an idea how to bind a particular application/program to specific IP address on solaris box?
Assume there is a server with two NICs with distinct IPs, I install an application (could be a backup sowftware client) and would like to tell to the... (6 Replies)
Dear all,
I am a newbie in solaris and I need your advice.
I have a Solaris version 5.9 installed on Sunfire V240.
I am able to ssh the machine from putty remotely.
My problem is that I cannot see the display from KVM switch I have connected to it. I need also to be able to see the GUI... (2 Replies)
Hi all
I have installed a demo version of SCO OpenServer 5.0.2, I finally found it is Desktop Interface, I would like to know how to change its interface to dos based interface?
If you have any ideas, please tell me then. Thank you (2 Replies)
This is my situation
DOS pc serial cable (sl0) Linux Pc eth1
192.168.0.10 <-------------------->192.168.0.2 <------------>192.168.0.1 (router)
I connected the linux pc and the dos pc with a SLIP (serial line internet protocol), so they can communicate in the sl0 interface.
... (3 Replies)
I have a RHEL 5 system with a bonded interface configure using only one network port (eth0). So I have config file for ifcfg-bond0 and ifcfg-eth. I'd like to configure eth5 to be the second SLAVE in the bond. My question is, after I modify ifcfg-eth5, can I add eth5 to the bond0 interface without... (1 Reply)