02-21-2020
Code :
Linc-HO>ping 164.52.194.12
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 164.52.194.12, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
Linc-HO>
Code :
Linc-HO>show ip interface
GigabitEthernet0/0 is up, line protocol is up
Internet address is 192.168.198.2/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Input features: MCI Check
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
GigabitEthernet0/1 is up, line protocol is up
Internet address is 172.16.80.100/16
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Input features: MCI Check
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
GigabitEthernet0/2 is down, line protocol is down
Internet address is 10.224.102.13/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Input features: MCI Check
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
Serial0/0/0 is down, line protocol is down
Internet address is 10.10.10.6/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is enabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Input features: MCI Check
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
Serial0/0/1 is down, line protocol is down
Internet address is 10.10.10.9/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is enabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Input features: MCI Check
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
Serial0/1/0 is down, line protocol is down
Internet address is 10.10.10.13/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is enabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Input features: MCI Check
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
Serial0/1/1 is up, line protocol is up
Internet address is 10.10.10.21/30
Broadcast address is 255.255.255.255
Address determined by non-volatile memory
Peer address is 10.10.10.22
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Local Proxy ARP is disabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is enabled
IP Flow switching is disabled
IP CEF switching is enabled
IP CEF switching turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast, CEF
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Policy routing is disabled
Network address translation is disabled
BGP Policy Mapping is disabled
Input features: MCI Check
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
10 More Discussions You Might Find Interesting
1. Shell Programming and Scripting
I have the following ftp script to get files from a remote location.
However, on running the script I find that I am not even able to connect to ftp server.
I am able to connect to ftp server using other GUI ftp tools like WS_FTP using the same IP.
IP used here is a dummy IP.
What can go... (3 Replies)
Discussion started by: gram77
3 Replies
2. AIX
Hi,
I have xmanager installed on my windows PC. But I am not able to connect to AIX server.
It's giving the error as follows:
The X11 forwarding request was rejected. Graphics mode is not coming up in AIX server.
Please help as I have to install oracle patchset urgently. (1 Reply)
Discussion started by: dwiravi
1 Replies
3. HP-UX
Hello All,
I am trying to connect to ftp server and get the files. Also i need to rename the file in other ftp dir.
rename method is not allowing me to rename the file in other dir. When i tried copy command by using net::FTP:FILE then perl says it is not installed.
Can some body help me to... (2 Replies)
Discussion started by: krsnadasa
2 Replies
4. UNIX for Advanced & Expert Users
Hi,
I have two unix servers A and B. from A i am trying to use the ftp command to connect to B but I am getting the "ftp: connect: A remote host refused an attempted connect operation."
I checked the following things :
1.) Unix Server details for A and B after running the command uname -a... (3 Replies)
Discussion started by: mick_000
3 Replies
5. Red Hat
hi all
i am unable to connect remote server using ssh but i am able to ping the server
ssh service is running. (5 Replies)
Discussion started by: nikhil kasar
5 Replies
6. Linux
How to generate public key to connect from one ftp server to other server to use in scripting. (0 Replies)
Discussion started by: sridhardwh
0 Replies
7. UNIX for Advanced & Expert Users
How to generate public key to connect from one ftp server to other server to use in scripting. (1 Reply)
Discussion started by: sridhardwh
1 Replies
8. Linux
Hi,
Could you please help me with the below issue..
I'm running RHEL6 OS on both server (192.168.0.10) and client machines (192.168.0.1).
I'm trying to connect to server from the client machine using ftp service.
I have installed vsftpd daemon on both the machines.
I'm getting... (4 Replies)
Discussion started by: raosr020
4 Replies
9. Solaris
Hi,
I am unable to connect sun server, server model is sun fire v440
on server 2 ports are there.
serial management, and network management.
I would like to know how to connect serial port if I dont have com port on my system? and on Network Management no ip address is configured.
... (2 Replies)
Discussion started by: manoj.solaris
2 Replies
10. Shell Programming and Scripting
Hi All,
We have done new FTB setup.
I am not able to to connect to this new target server.
Here is the new setup to send files to the FTB :
- Login : FTB-TAN-DEV-SAP
- Protocol : SFTP
- Port : 54322
- Hostname : ftb-dev.apj.hp
- Env : DEV
- Target ID : 3225
I tried connecting to the... (5 Replies)
Discussion started by: ROCK_PLSQL
5 Replies