IPMP group failed on Solaris 9 Post: 303038574

9 More Discussions You Might Find Interesting

1. Solaris

Solaris IP Multipathing (IPMP) Help

Hello All, I work for a Health care company at a local trauma hospital. I maintain a Picture Archiving and Communication System (PAC's). Basically, any medical images (X-Ray, CT, MRI, Mammo, etc) are stored digitally on the servers for viewing and dictation from diagnostic stations. I took over...

2. Solaris

Does Veritas Cluster work with IPMP on Solaris 10?

Does Veritas Cluster work with IPMP on Solaris 10? If anyone has set it up do you have a doc or tips? I have heard several different statements ranging from , not working at all to Yes it works! Great How? * Test and Base IPs???? * configure the MultiNICB agent ? I can give details...

3. Solaris

IPMP group failure when gateway not detected

A problem happened with me, I was configuring IP for two network interfaces, and when I rebooted the system, everything is working but after like 3 or 5 minutes it will tell me that the whole IPMP group has failed ! I tried to troubleshoot, so I found that the gateway is not reachable..so I...

4. Solaris

how to configure IPMP in solaris 9

Hi friends , can anyone provide me the complete steps to configure IPMP in solaris 9 or 10 provided i have two NIC card ? regards jagan

5. Solaris

Solaris IPMP

Can any one please explain me the concept behind IPMP in solaris clustering.Basic explanation would be really appreciated... Thanks in Advance vks

6. Solaris

Solaris 10 branded zone with IPMP

All. I am trying to create a 10 branded zone on a Sol 11.1 T5. The Global is using IPMP...so aggregating is out of the question. Has anyone successfully created a branded zone with IPMP? If they have can you please show me the steps you took to get this to run. Thanks

7. Solaris

IPMP over aggregate in Solaris 11

hi all, i start with solaris 11 and i am disapointed by the change on ip managing. i want to set a ipmp over tow aggregate but i dont find any doc and i am lost with the new commande switch1 net0 aggregate1 | net1 aggregate1 |-----| |...

8. Solaris

New to Solaris IPMP (conversion from Linux)

Hi all, I been reading examples of how to setup IPMP and how it differs from Etherchannel. However, i am still unsure of how it really works and i hope gurus here can shed some light on the questions I have below while i will lab it up for my own test -> q1) for IPMP, there is no such thing...

9. Solaris

Solaris 10 IPMP - failback=no

Hi all, Just a few questions -> Is an "OFFLINE" interface going back to "ONLINE" consider as a failback by IPMP ? I have "FAILBACK=no" in my /etc/default/mpathd; however when i do the following (igb0 and igb7 are in the same ipmp link based group) q1) why does "if_mpadm -r igb7" cause...

LEARN ABOUT REDHAT

aggregate-ios

AGGREGATE-IOS(1)					      General Commands Manual						  AGGREGATE-IOS(1)

NAME

       aggregate-ios - optimise a concatenated set of cisco/IOS prefix filters to help make them nice and short.

SYNOPSIS

       aggregate-ios <source_config >optimised_config

DESCRIPTION

       Takes  cisco IOS configuration on stdin, and optimises any prefix filters found using aggregate(1).  Optimised filters are produced on std-
       out.

OPTIONS

       None.

DIAGNOSTICS

       Any diagnostics produced by aggregate(1) are passed through on stderr.

EXAMPLES

       The following configuration fragment:

	 ip prefix-list AS65530 description Foo, Inc
	 ip prefix-list AS65530 permit 10.1.0.0/16
	 ip prefix-list AS65530 permit 10.2.0.0/16
	 ip prefix-list AS65530 permit 10.2.1.0/24
	 ip prefix-list AS65530 permit 10.3.0.0/16
	 ip prefix-list AS65531 description Bar.Com
	 ip prefix-list AS65531 seq 5 permit 192.168.1.0/24
	 ip prefix-list AS65531 seq 10 permit 192.168.2.0/24
	 ip prefix-list AS65531 seq 15 permit 192.168.0.0/19

       is optimised as follows:

	 ip prefix-list AS65530 permit 10.1.0.0/16 le 24
	 ip prefix-list AS65530 permit 10.2.0.0/15 le 24
	 ip prefix-list AS65531 permit 192.168.0.0/19 le 24

SEE ALSO

       aggregate(1)

HISTORY

       Aggregate-ios was written by Joe Abley <jabley@mfnx.net>.

BUGS

       All those in aggregate(1) and then some :)

Joe Abley							 2000 November 27						  AGGREGATE-IOS(1)