Login or Register to Ask a Question and Join Our Community

Sponsored Content
Full Discussion: Misconfiguration detected Adapter interface name en 3 Adapter offset 0
Operating Systems AIX Misconfiguration detected Adapter interface name en 3 Adapter offset 0 Post 303035972 by RecoveryOne on Tuesday 11th of June 2019 08:24:55 AM
Old 06-11-2019
bakunin, all very good points.
Still thinking single user mode if they can't get control of the console would be beneficial at least from a troubleshooting standpoint. Would let them see adapters, if any...See below:


Something else that concerned me from the boot log was this line:
Code:
The Service Request Number is B7006970: I/O subsystem (hub, bridge, bus) Unrecovered Error, general

I looked that up and that's coming out to be a PCI host bridge failure message. Likely the system doesn't see its adapters at all. I might be off, and my IBMer isn't available to confirm for me. Depending on whats causing the failure message, you may need a system backplane or I/O backplane replacement. Which would explain why your direct attached console isn't working.


There's other PCI I/O adapters that can cause that error, however I feel such efforts might be beyond the scope of this forum, and you'd best be off finding a 3rd party support or be willing to shell out some insane dollar amount to IBM for service.
 

10 More Discussions You Might Find Interesting

1. IP Networking

LAN Adapter

Im newest in unix, Please, give me solution for installing lan adapter if driver not found in the list of ethernet drivers ihave unix driver in a dos diskete please give me the other solution and tell me where the domain of unix class online, so ican read from it. Thank's very much (3 Replies)
Discussion started by: ade_muhdiat
3 Replies

2. Solaris

Which SCSI Adapter?

Hi. I need to find a simple SCSI adapter card for a Sun Ultra 5 workstation. I don't need the type w/ ethernet attached (e.g. X1032) as I already have ethernet onboard & they are more spendy. I know Adaptec is out, but what unit would work? I am attaching an external SCSI tape unit to this... (4 Replies)
Discussion started by: Plain Person
4 Replies

3. Solaris

Creator 3D Video Adapter

Hi everyone, it's me the Solaris novice once again. Here's my situation. - I bought a Sun Ultra 10 Creator 3D Workstation and Sony 19" SVGA Monitor package deal. - The system has the Creator 3D Video Adapter installed but I could not use it because the adapter has a 13w3 connection and my... (5 Replies)
Discussion started by: jbarbuto
5 Replies

4. HP-UX

what is an adapter?

Hi , Hi what is an adapter?what is its use ? How to log into a tibco server from unix home directory. (1 Reply)
Discussion started by: megh
1 Replies

5. UNIX for Dummies Questions & Answers

Simulated driver for Network Interface Adapter

Hi all, I got sort of a task to do. I have to write in C "simulated network driver". What does it mean? - It has to run on all network adapters - It has to be as simple as it can be - It has to run on all linux distributions (or at least most of them) - It does not have to run a network... (4 Replies)
Discussion started by: Chrisdot
4 Replies

6. SCO

Installing LAN adapter

I inserted a PCI Realtek RTL8139 network adapter on a PC running SCO Openserver 5.0.6. I successfully loaded drivers and I'm trying to install the card with netconfig command, unfortunately without success. Here are the steps I follow to install the card: I run netconfig, from menu 'hardware'... (2 Replies)
Discussion started by: kampus
2 Replies

7. Hardware

SCSI Ultra320 80->68 adapter

I need to connect 80pin SCA Ultra320 SCSI hdd to 68pin. There are rumors that some bad "passive" adapters with problematic termination can fry the HDD. The adapter we got is Assmann ABSCA-2. Hard drive is 'Fujitsu MAW3073NC' Do we need to set any jumpers before turning it on? We already had... (0 Replies)
Discussion started by: orange47
0 Replies

8. AIX

Dedicate graphics adapter ?

Hello, Runing VIO and couple lpars on POWER blade. I want to dedicate graphics adapter(ati0) to one lpar. Is that possible ? I tried to do that using IVM (I/O Adapter Management->View/Modify Physical Adapters->Modify partition assignment): Failed to remove adapter U78A6.001.WIH4088-P2-C8... (1 Reply)
Discussion started by: vilius
1 Replies

9. AIX

Vscsi and npiv on same adapter

Hi, I want to change from vscsi to npiv. Is it possible to use both on the same adapter, so we can change the systems one by one, or must we place a second FC adapter in the VIO servers? Thanks, Ronald (2 Replies)
Discussion started by: ronaldm60
2 Replies

10. Red Hat

Ethernet Adapter not detected.

Hi, I have installed Oracle Enterprise Linux 5 in my PC. After the installation the Ethernet Card is not got detected. But I could able to get the details using the command lspci -a: 01:00.0 Ethernet controller: Attansic Technology Corp. L1 Gigabit Ethernet Adapter (rev b0). But I could... (4 Replies)
Discussion started by: chidhu.anu
4 Replies

LEARN ABOUT SUNOS

i2o_scsi

i2o_scsi(7D)							      Devices							      i2o_scsi(7D)

NAME

       i2o_scsi - an I2O OS specific module that supports SCSA interface.

DESCRIPTION

       The i2o_scsi OSM module is a SCSI HBA driver that supports the SCSA interface.
	It  supports  both SCSI Adapter Class and SCSI Peripheral Class functions. It translates the SCSI packet coming down from the SCSA into an
       I2O SCSI Peripheral Class message, passes it along to the IOP which in turn passes it to the HDM (hardware specific module).

       It also uses SCSI Adapter Class functions to manage the SCSI adapter and SCSI bus.  For each SCSI Adapter Class I2O  device  (a	SCSI  con-
       troller),  it claims the SCSI Peripheral class devices which are attached to that port. The existing SCSI target drivers which use the SCSA
       interface should only work with i2o_scsi. This includes target drivers like sd, st and so on.

FILES

       /kernel/drv/i2o_scsi.conf       configuration file for the i2o_scsi driver; there are no user-configurable options in this file

ATTRIBUTES

       See attributes(5) for descriptions of the following attributes:

       +-----------------------------+-----------------------------+
       |      ATTRIBUTE TYPE	     |	    ATTRIBUTE VALUE	   |
       +-----------------------------+-----------------------------+
       |Architecture		     |x86			   |
       +-----------------------------+-----------------------------+

SEE ALSO

       attributes(5)

	Solaris 10 Installation Guide: Basic Installations

SunOS 5.10							    23 Jan 2001 						      i2o_scsi(7D)
All times are GMT -4. The time now is 04:02 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy