]I am a bit confused: is this a disk in your AIX system as you said in #1 or a disk in a separate RAID as you said in #2? Usually, if you have an external raid, by formatting it forms one virtual disk (the whole RAID set) which you then in turn can see in AIX as a single hdisk device. Please explain your hardware setup (what is connected to what, etc.) a bit more detailed.
--> My hardware setup is that I have a RAID5 disk hdisk5 (inside it are the pdiskx).
My volume group
My raid configuration
We have pulled out the failure disk pdisk5 and added a new hard disk.
Anything is fine until trying to add the new disk to the RAID and encountered the issue below:
After some checks, I can see the hdisk5 becomes bigger with new size but the VG still in the old size.
Hi,
Other than df -k, is there any command that will tell me all physical hard drives installed on the system as well as the size of each one?
I'm using AIX 5.1
Thanks, (3 Replies)
I am new to being a Unix admin and have a question about replacing some hardware. I have a K class box using HP-UX 10.20 with three disks. Two of the drives are in one logical volume. Every 3 or 4 days, the syslog is showing that one of these drives is experiencing "POWERFAILED" and then recovering... (6 Replies)
Hi people, I have been using my disk for quite a long time but the other day I heard the drive making some noise and had to restart the system again. But when I did that the disk would not boot and I fear that the data might be deleted or lost. So, if you people have any know about the ways to get... (1 Reply)
Hi people,
I have been using my disk for quite a long time but the other day I heard the drive making some noise and had to restart the system again. But when I did that the disk would not boot and I fear that the data might be deleted or lost. So, if you people have any know about the ways to... (2 Replies)
hi all,
have a solaris 9 OS and a SAN disk which used to work fine is not getting picked up by my machine. can anyone point out things to check in order to troubleshoot this ??
thanks in advance. (3 Replies)
hi
I've a fresh installation of SCO 5.0.7 on the IDE hard disk.
For SCSI hard disk I can declare, for example blc disk driver using:
# mkdev hd 0 SCSI-0 0 blc 0but it works for IDE hard disk? (3 Replies)
in red hat 4, 5 any one know any commands or any scritps to monitor HP DL 380 G5/6 server and trigger alarm when hard disk failed.
thanks for all support
---------- Post updated at 02:45 PM ---------- Previous update was at 12:00 PM ----------
does HP ProLiant Support Pack support is... (4 Replies)
Hi all,
I'm kind of new to programming in Linux & c/c++. I'm currently writing a FileManager using Ubuntu Linux(10.10) for Learning Purposes. I've got started on this project by creating a loopback device to be used as my virtual hard disk. After creating the loop back hard disk and mounting it... (23 Replies)
Hello to all,
Im having a new task in a new world (AIX - IBM Servers)
I have an IBM Server (Type - 9111-285 very old one) with one Hard disk (73 GB 10 K) with AIX 5.x, and I need to clone the existing disk to another with the same specifications.
Could you please give me some advice in order... (7 Replies)