Sponsored Content
Full Discussion: Boot Issues
Operating Systems Linux Red Hat Boot Issues Post 303030829 by ASGR on Saturday 16th of February 2019 05:22:31 PM
Old 02-16-2019
Sounds like it is more of a Hyper-V problem than a Red-Hat issue.
It may well be that Hyper-V didn't support newer technology that
Red-Hat may have implemented at the time.


When running any guest OS through a hypervisor, you should try
the hypervisor forums first. This isn't a Windows 10 forum.
 

7 More Discussions You Might Find Interesting

1. UNIX for Advanced & Expert Users

Solaris boot issues

i'm having 2 problems. 1. the system will always look to boot from the net. i've changed the prom settings so that it boots from the disk, by entering "setenv boot-device disk0:3", but the system still seems to want to boot from the net. 2. i replaced my creator3d with an elitem6 and i did... (6 Replies)
Discussion started by: xyyz
6 Replies

2. UNIX for Advanced & Expert Users

boot issues...

hardware on my first FreeBSD server has crashed. i was planning on swapping the HD into another machine, booting the generic kernel and then custom tailoring it to the new machine specs. however, i'm having a problem. the new machine is using a promise ultra100 card. i don't have any... (2 Replies)
Discussion started by: xyyz
2 Replies

3. Solaris

V1280 boot issues

I have a client with a V1280 onsite and it is having boot problems. Below is the message it is returning when trying to boot. Is this something that anybody has run into, or that you might be able to shed some light on? {0} ok boot /ssm@0,0/pci@18,700000/ide@3/cdrom@0,0:f SunOS Release 5.9... (3 Replies)
Discussion started by: xcwhitex
3 Replies

4. SCO

xp/sco 5.0.7 dual boot issues

Hello those more knowledgeable than I: I have been trying to get xp and SCO to coexist on the same system. I have tried several different ways to make both work, here's the list: -install xp, image it, move the partition to the end of drive, verify it boots, image again, -boot off of SCO... (6 Replies)
Discussion started by: stay0ut
6 Replies

5. Solaris

Windows,Solaris, Red Hat triple boot issues

I have a pentium IV with 512 MB ram and 80 GB HDD. I first installed windows XP on the first primary partition, then Solaris on the second with 20 GB for the solaris partition, and when rebooted , the grub menu functioned as expected giving me the options to dual boot, so next I wanted to install... (3 Replies)
Discussion started by: saagar
3 Replies

6. Solaris

Boot issues Solaris 10 + V440

Hello, I've a very weird problem with one of the machines. When I try to boot off a working DVD that I used to install another system with it spits out the following message: Sun Fire V440, No Keyboard Copyright 2007 Sun Microsystems, Inc. All rights reserved. OpenBoot 4.22.33, 8192 MB... (14 Replies)
Discussion started by: stoci
14 Replies

7. Solaris

WAN boot Server issues.

I 'm trying to configure a WAN boot server on Solaris10 x86 for sparc clients .. when i try to set up the server m getting following error ./setup_install_server -w /var/apache2/htdocs/wanboot10/wpath /var/apache2/htdocs/wanboot10/ipath ERROR: Cannot make WAN boot Image file on this... (6 Replies)
Discussion started by: fugitive
6 Replies
HYPER-V(4)						   BSD Kernel Interfaces Manual 						HYPER-V(4)

NAME
hv_vmbus -- Hyper-V Virtual Machine Bus (VMBus) Driver SYNOPSIS
To compile this driver into the kernel, place the following lines in the system kernel configuration file: device hyperv DESCRIPTION
The hv_vmbus provides a high performance communication interface between guest and root partitions in Hyper-V. Hyper-V is a hypervisor-based virtualization technology from Microsoft. Hyper-V supports isolation in terms of a partition. A partition is a logical unit of isolation, supported by the hypervisor, in which operating systems execute. The Microsoft hypervisor must have at least one parent, or root, partition, running Windows Server operating system. The virtualization stack runs in the parent partition and has direct access to the hardware devices. The root partition then creates the child partitions which host the guest operating systems. Child partitions do not have direct access to other hardware resources and are presented a virtual view of the resources, as virtual devices (VDevs). Requests to the virtual devices are redirected either via the VMBus or the hypervisor to the devices in the parent partition, which handles the requests. The VMBus is a logical inter-partition communication channel. The parent partition hosts Virtualization Service Providers (VSPs) which com- municate over the VMBus to handle device access requests from child partitions. Child partitions host Virtualization Service Consumers (VSCs) which redirect device requests to VSPs in the parent partition via the VMBus. The Hyper-V VMBus driver defines and implements the interface that facilitate high performance bi-directional communication between the VSCs and VSPs. All VSCs utilize the VMBus driver. SEE ALSO
hv_ata_pci_disengage(4), hv_netvsc(4), hv_storvsc(4), hv_utils(4) HISTORY
Support for hv_vmbus first appeared in FreeBSD 10.0. The driver was developed through a joint effort between Citrix Incorporated, Microsoft Corporation, and Network Appliance Incorporated. AUTHORS
FreeBSD support for hv_vmbus was first added by Microsoft BSD Integration Services Team <bsdic@microsoft.com>. BSD
September 10, 2013 BSD
All times are GMT -4. The time now is 02:58 AM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy