Apologies for the delay, I am a carer or babysitter presently for my mother or grandchild and dogs.
However @ Corona688...
Well tested your 'BASH' version with just one edge case and there will be quite a few...
Note with your original, 2.0 - 3.14159 = -1.141, not what is shown.
Then I just did one edge case, I changed '2.0' to '0.073' and...
NOTE: Not related to either your or my versions; I have manually found many edgecases. Python was a godsend for this task.
As I said I have learnt a lot about 'dash' and POSIX. Your 'heredoc' code is wonderful.
As above I have found many edge cases.
Also the strange effects closing the gaps to the + or - limits I have set.
I will be back ASAP but family comes first.
Last edited by wisecracker; 11-24-2018 at 05:37 AM..
Reason: Correct grammar.
Anyone know of a guide or instructions for Solaris
I got to configure a SBUS HBA to talk to a tape robot.
I have done this on a switch but not point to point.
just going HBA >>>>> TAPE Fibre simple two nodes
Kie (6 Replies)
Hi!
I'm new in these forums and more or less new with Unix. So... here is the question:
does anyone know where is redirected the output of a command when you put >&- after it?
Does it means any standard file descriptor?
Thanks! (2 Replies)
hi,
I would like to ask or is it possible to dump a hex using dd from starting point to end point just like the "xxd -s 512 -l 512 <bin file>"
I know the redirect hexdump -C but i can't figure it out the combination options of dd.
Hope someone can share their knowledge..
Thanks in... (3 Replies)
Discussion started by: jao_madn
3 Replies
4. Post Here to Contact Site Administrators and Moderators
HI Everyone,
I have below source file
AAA|NAME1|ADDRESS1|300.20
BBB|NAME2|ADDRESS2|400.31
CCC|NAME3|ADDRESS3|300.34
I have requirement where I need to sum up fourth field in above fixed width pipe delimited flat file. When I use below code, it gives me value 1001.00
But I am expecting... (1 Reply)
Hey all! :)
I'm trying to create a fixed mount point for an usb cardreader.
I've found a script on a raspberry pi forum which does the following:
usb stick is plugged in -> script checks the mount point for data -> script starts copying the files automatically -> script unmounts the... (0 Replies)
How to create a new mount point with 600GB and add 350 GBexisting mount point
Best if there step that i can follow or execute before i mount or add diskspace IN AIX
Thanks (2 Replies)
Well, guys I saw a question about GOTO for Python.
So this gave me the inspiration to attempt a GOTO function for 'dash', (bash and ksh too).
Machine: MBP OSX 10.14.3, default bash terminal, calling '#!/usr/local/bin/dash'...
This is purely a fun project to see if it is possible in PURE... (3 Replies)