Here's a quick bash-only version for positive numbers. The trick is reading the values in. Once you do that the rest is straightforward.
I can see what you are doing, but forgive my ignorance; apart from the obvious bashisms, how do I use 'read' to input values directly from command line arguments without disk thrashing in POSIX 'dash'?
Everything MUST centre around 'dash' or POSIX 'sh'.
As for 'zsh', I can't be responsible for a non POSIX compliant shell.
This is the whole point of this [futile] exercise to see what is possible and what better than Fixed Point Arithmetic.
And I already assume a "fractional" part of 1000000000 and use "%.9f" to add any zeros to the end.
Anyhow I will try out your "MINUS" modification tomorrow.
Multiplication and division are harder still in 'dash'.
Anyone know of a guide or instructions for Solaris
I got to configure a SBUS HBA to talk to a tape robot.
I have done this on a switch but not point to point.
just going HBA >>>>> TAPE Fibre simple two nodes
Kie (6 Replies)
Hi!
I'm new in these forums and more or less new with Unix. So... here is the question:
does anyone know where is redirected the output of a command when you put >&- after it?
Does it means any standard file descriptor?
Thanks! (2 Replies)
hi,
I would like to ask or is it possible to dump a hex using dd from starting point to end point just like the "xxd -s 512 -l 512 <bin file>"
I know the redirect hexdump -C but i can't figure it out the combination options of dd.
Hope someone can share their knowledge..
Thanks in... (3 Replies)
Discussion started by: jao_madn
3 Replies
4. Post Here to Contact Site Administrators and Moderators
HI Everyone,
I have below source file
AAA|NAME1|ADDRESS1|300.20
BBB|NAME2|ADDRESS2|400.31
CCC|NAME3|ADDRESS3|300.34
I have requirement where I need to sum up fourth field in above fixed width pipe delimited flat file. When I use below code, it gives me value 1001.00
But I am expecting... (1 Reply)
Hey all! :)
I'm trying to create a fixed mount point for an usb cardreader.
I've found a script on a raspberry pi forum which does the following:
usb stick is plugged in -> script checks the mount point for data -> script starts copying the files automatically -> script unmounts the... (0 Replies)
How to create a new mount point with 600GB and add 350 GBexisting mount point
Best if there step that i can follow or execute before i mount or add diskspace IN AIX
Thanks (2 Replies)
Well, guys I saw a question about GOTO for Python.
So this gave me the inspiration to attempt a GOTO function for 'dash', (bash and ksh too).
Machine: MBP OSX 10.14.3, default bash terminal, calling '#!/usr/local/bin/dash'...
This is purely a fun project to see if it is possible in PURE... (3 Replies)