BRIDGE(4)						   BSD Kernel Interfaces Manual 						 BRIDGE(4)

NAME

     bridge -- network bridge device

SYNOPSIS

     pseudo-device bridge

DESCRIPTION

     The bridge driver creates a logical link between two or more IEEE 802 networks that use the same (or ``similar enough'') framing format.  For
     example, it is possible to bridge Ethernet and 802.11 networks together, but it is not possible to bridge Ethernet and Token Ring together.

     To use bridge, the administrator must first create the interface and configure the bridge parameters.  The bridge is created using the
     ifconfig(8) create subcommand.  The learning and forwarding behavior and other parameters of a bridge are configured by the brconfig(8) util-
     ity.

     A bridge can be used to provide several services, such as a simple 802.11-to-Ethernet bridge for wireless hosts, and traffic isolation.

     A bridge works like a switch, forwarding traffic from one interface to another.  Multicast and broadcast packets are always forwarded to all
     interfaces that are part of the bridge.  For unicast traffic, the bridge learns which MAC addresses are associated with which interfaces and
     will forward the traffic selectively.

     The bridge driver implements the IEEE 802.1D Spanning Tree protocol (STP).  Spanning Tree is used to detect and remove loops in a network
     topology.

     Transparent filtering for IP and IPv6 packets can be added with the kernel configuration option options BRIDGE_IPF.

     When filtering is enabled, bridged packets will pass through the filter inbound on the originating interface and outbound on the appropriate
     interfaces.  ARP and REVARP packets are forwarded without being filtered and others that are not IP nor IPv6 packets are not forwarded when
     filtering is enabled.

     Note that packets to and from the bridging host will be seen by the filter on the interface with the appropriate address configured as well
     as on the interface on which the packet arrives or departs.

SEE ALSO

     etherip(4), options(4), brconfig(8), ipf(8)

HISTORY

     The bridge driver first appeared in NetBSD 1.6.

AUTHORS

     The bridge driver was originally written by Jason L. Wright <jason@thought.net> as part of an undergraduate independent study at the Univer-
     sity of North Carolina at Greensboro.

     This version of the bridge driver has been heavily modified from the original version by Jason R. Thorpe <thorpej@wasabisystems.com>.

BUGS

     The bridge driver currently supports only Ethernet and Ethernet-like (e.g. 802.11) network devices, with exactly the same interface MTU size
     as the bridge device.

     The bridge driver currently does not support snooping via bpf(4).

BSD
								  January 9, 2010							       BSD