HP C8000 with HP-UX 10.20 Post: 302984854

Sponsored Content

Operating Systems HP-UX HP C8000 with HP-UX 10.20 Post 302984854 by darkox on Tuesday 1st of November 2016 11:05:04 AM

11-01-2016

Registered User

Thank you for reply, vbe,

Just a bit more information about my case.

I am currently using B2600 box which has PA-8600 64bit processor with multiple PCI interface cards, Ultra 2 SCSI hard drive and even IDE CD-ROM and USB. I built that box using the same installation disk (ACE 5 with 1994 ISL) with no problem.

For this reason I do not want to believe it is something to do with 64bit compatibility. However, it seems these boxes using different SCSI controllers, B2600 is using Ultra 2 SCSI LVD while C8000 Ultra 320 SCSI... Might this be an issue?

Regards,

D.

Last edited by darkox; 11-01-2016 at 12:34 PM..

darkox

View Public Profile for darkox

Find all posts by darkox

2 More Discussions You Might Find Interesting

1. HP-UX

HP UX 11i and HP C8000

Hey, i want install HP UX 11i on HP C8000. When i start the C8000 i get a prompt. On this Prompt i write BOot P1 P1 is my DVD-ROM (IDE). I get the Message "ERROR: Not a boot path". When i write SEArch the Prompt said: P0 scsiA.6 HP73.4MAT3073NP P1 ide.1 ...

2. HP-UX

Help needed HP UX 11.11i new install on C8000 Desktop messaging system error CAN'T FIX

Hi, I have a HP UX C8000 box , have installed 11.11i from 4 x cds numerous times to try to get a functioning Network or to try and get rid of this error on start up, after new install and 1st startup I get an error "The desktop messaging system could not be started" and then advice about...

LEARN ABOUT FREEBSD

snd_maestro

SND_MAESTRO(4)						   BSD Kernel Interfaces Manual 					    SND_MAESTRO(4)

NAME

     snd_maestro -- ESS Maestro bridge device driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device sound
	   device snd_maestro

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   snd_maestro_load="YES"

DESCRIPTION

     The snd_maestro bridge driver allows the generic audio driver sound(4) to attach to ESS Maestro based sound chips.  This chipset is very pop-
     ular in notebook computers, but it is also very used in a wide selection of cheap OEM sound cards.

HARDWARE

     The snd_maestro driver supports the following PCI sound cards:

     o	 ESS Technology Maestro-1
     o	 ESS Technology Maestro-2
     o	 ESS Technology Maestro-2E

SEE ALSO

     snd_maestro3(4), sound(4)

HISTORY

     The snd_maestro device driver first appeared in FreeBSD 4.2.

AUTHORS

     This manual page was written by Jorge Mario G. Mazo <jgutie11@eafit.edu.co>.

BSD
								 December 15, 2005							       BSD