HP C8000 with HP-UX 10.20 Post: 302984851

Sponsored Content

Operating Systems HP-UX HP C8000 with HP-UX 10.20 Post 302984851 by vbe on Tuesday 1st of November 2016 10:49:22 AM

11-01-2016

Moderator

What I see is that aC8000 is a pure 64 bit machine, and I dont remember if you had a 10.20 in 64 bits, as I always had 10.20 in 32 bit even for first 64 bits compatible box like K3XX series, then at the time of 10.20 there were no PCI slots nor could I remember of ultraSCSI the boxes had FW-SCSI2 perhaps and HSC expansion.., I would not say its impossible, but I would start by looking for the last HP 10.20 archive ( dec 2001 I think ) and look what firmware upgrades wer given, then look if any extra patches ( firware were released ) you could use to be compatible, and of course look in you can run in 32bit as it was possible with the first generations of PA8000 but here you have a PA 8800....

vbe

View Public Profile for vbe

Find all posts by vbe

2 More Discussions You Might Find Interesting

1. HP-UX

HP UX 11i and HP C8000

Hey, i want install HP UX 11i on HP C8000. When i start the C8000 i get a prompt. On this Prompt i write BOot P1 P1 is my DVD-ROM (IDE). I get the Message "ERROR: Not a boot path". When i write SEArch the Prompt said: P0 scsiA.6 HP73.4MAT3073NP P1 ide.1 ...

2. HP-UX

Help needed HP UX 11.11i new install on C8000 Desktop messaging system error CAN'T FIX

Hi, I have a HP UX C8000 box , have installed 11.11i from 4 x cds numerous times to try to get a functioning Network or to try and get rid of this error on start up, after new install and 1st startup I get an error "The desktop messaging system could not be started" and then advice about...

LEARN ABOUT DEBIAN

snd_maestro

SND_MAESTRO(4)						   BSD Kernel Interfaces Manual 					    SND_MAESTRO(4)

NAME

     snd_maestro -- ESS Maestro bridge device driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device sound
	   device snd_maestro

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

	   snd_maestro_load="YES"

DESCRIPTION

     The snd_maestro bridge driver allows the generic audio driver sound(4) to attach to ESS Maestro based sound chips.  This chipset is very pop-
     ular in notebook computers, but it is also very used in a wide selection of cheap OEM sound cards.

HARDWARE

     The snd_maestro driver supports the following PCI sound cards:

     o	 ESS Technology Maestro-1
     o	 ESS Technology Maestro-2
     o	 ESS Technology Maestro-2E

SEE ALSO

     snd_maestro3(4), sound(4)

HISTORY

     The snd_maestro device driver first appeared in FreeBSD 4.2.

AUTHORS

     This manual page was written by Jorge Mario G. Mazo <jgutie11@eafit.edu.co>.

BSD
								 December 15, 2005							       BSD