IBM Power Linux Cluster Fence device on Power8 Platform Post: 302983102

6 More Discussions You Might Find Interesting

1. Solaris

Increasing Raw device Sun Cluster 3.0

Hi All , I would like to know the procedure for increasing shared volume space in sun cluster . Currently the configuration is like these . Main stripe oradb1/d91 2 1 /dev/did/rdsk/d35s0 1 /dev/did/rdsk/d36s0 =Total 49 Gb oradb1/d94 -p oradb1/d91 -o 88080480 -b 14680064 ==Total 7 GB...

2. AIX

IBM Power Pseries Open Firmware boot / VIOS POWERVM VET CODE

Hello, I installed PowerVM IVM Virtual I/O on P-550 but later found out that the machine isn't activated for CoD VET code for virtualization. So when booted , it goes into OPEN Firmware I/O Hosting requires a hosting partition boot not permitted exit called > ok Panel shows > IO...

3. AIX

New IBM Power8 (S822) and StorWiz V3700 SAN, best practices for production setup/config?

Hello, Got a IBM Power8 box (S822) that I am configuring for replacement of our existing IBM machine. Wanted to touch base with the expert community here to ensure I don't miss anything critical in my setup/config of AIX. Did a fresh AIX 7.1 install on the internal scsi hdisk, mirror'ed...

4. Red Hat

PaceMaker Cluster Fence Device

I have 2 VM's setup with a shared VMware disk running RHEL 7.1 (just updated to 7.2 with yum update), and would like to know what is the easiest Fence device to implement for testing purposes. Apparently, I need a fence device before my IP resources will come online. I have the cluster...

5. Solaris

Solaris Cluster Device Problem

I build up two node cluster (node1, node2) in virtualbox. For these two nodes I add 5 shared disk. (Also each node have own OS disk). 1 shared disk for vtoc 2 shared disk for NFS resource group 2 shared disk for WEB resource group When I finished my work; two nodes was ok and shared disk...

6. AIX

IBM Power 740 won't boot after firmware update

A team member installed the wrong version of License Code on a Power 740 system used in our Development environment. The system will no longer boot. Does anyone have IBM documentation or experience to share on recovering a system that currently reports "Unsupported License Code version...

LEARN ABOUT NETBSD

ipmi

IPMI(4) 						   BSD Kernel Interfaces Manual 						   IPMI(4)

NAME

     ipmi -- Intelligent Platform Management Interface driver

SYNOPSIS

     ipmi0 at mainbus?

DESCRIPTION

     The ipmi device driver supports motherboards implementing the Intelligent Platform Management Interface version 1.5 or 2.0, and exports sen-
     sors and the watchdog through the envsys(4) interface.

EVENTS

     The ipmi driver is able to send events to powerd(8) when a sensor's state has changed.  Intrusion sensors will send a critical event when
     state is not ok.  Power Supply sensors will send a critical event when the Power Supply unit is not installed and warning-over when the Power
     Supply unit is installed but not powered on.  Fan, temperature and voltage sensors will send critical-over or critical-under when the value
     is very critical, or warning-over or warning-under if it's in a warning alert.

SEE ALSO

     envsys(4), envstat(8), powerd(8), wdogctl(8)

HISTORY

     The ipmi driver first appeared in OpenBSD 3.9 and was then ported to NetBSD 4.0.

AUTHORS

     The ipmi driver was originally written by Jordan Hargrave and was ported to NetBSD by Manuel Bouyer <bouyer@NetBSD.org>.

BSD
								 September 8, 2008							       BSD