Trying to mount a drive which has been dropped after corruption.
What is the quickets and esiest command to run and which switches? cheers
olly (1 Reply)
hi-
I just installed a quad gigaswift ethernet scsi card to my sunblade 150. I checked with the docs, and got all of the required drivers on the box. Now, I'm trying to mount an external scsi tape drive with no luck. I set the scsi address on the external drive to 0. Here's what I'm coming... (9 Replies)
I'm trying to mount tape drive so I can tar from a cd.
this is what i type: mount /dev/rsd2940.4 /mnt
this is what i get: mount /dev/rsd2940.4 on /mnt : Block device required
I have no idea what that is supposed to mean. It's my understanding that rsd2940.4 is the block device. An... (1 Reply)
Hi,
Would appreciate if anyone could tell me if it is possible to mount (and use) a remote tape drive on a AIX server, and if so, what are the precise configuration steps needed?
The tape drive to be mounted as a remote tape drive is present on another AIX server in the same network.
... (0 Replies)
Hi,
Would appreciate if anyone could tell me if it is possible to mount (and use) a remote tape drive on a AIX server, and if so, what are the precise configuration steps needed?
The tape drive to be mounted as a remote tape drive is present on another AIX server in the same network.
... (5 Replies)
Hi there: I'm new here
Can anyone help me:
I have DS15 Alpha server : Unix 5.1B
Now i need to connect a DLVT VS80 1U Rackmount Tape Drive unit.
What is the exact comman to mount the DLTape IV??
How do i make backuo @ copy file to the tape?
Thanx to all (0 Replies)
Dear all,
I have a AIX server with logical 3 partitions and the server is connecting a tape drive. the first partition can successfully making a system backup to the tape but how can i fail to mount the tape to second and thrid partition. would anyone can help me to deal with it? what command... (3 Replies)
Discussion started by: rickhlwong
3 Replies
LEARN ABOUT FREEBSD
ahb
AHB(4) BSD Kernel Interfaces Manual AHB(4)NAME
ahb -- Adaptec EISA SCSI host adapter driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your kernel configuration file:
device scbus
device ahb
Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):
ahb_load="YES"
DESCRIPTION
This driver provides access to the SCSI bus connected to an Adaptec AHA-174X host adapters in ``enhanced'' mode. Tagged queueing and syn-
chronous SCSI transfers are supported.
HARDWARE
The ahb driver supports the following SCSI host adapters:
o Adaptec AHA-1740
o Adaptec AHA-1742
o Adaptec AHA-1740A
o Adaptec AHA-1742A
SEE ALSO aha(4), ahc(4), aic(4), cd(4), da(4), sa(4), scsi(4)AUTHORS
The ahb driver was written by Justin T. Gibbs.
CAVEATS
The Adaptec 174X is very sensitive to SCSI bus termination and cable length. It may also have difficulties operating with some modern
devices that, due to their speed, expose timing problems in the controller. There are no known mechanisms for working around device incom-
patibilities of this nature.
BSD July 4, 2004 BSD