Sponsored Content
Full Discussion: Hashsums and collisions
Special Forums Cybersecurity Hashsums and collisions Post 302966267 by orange47 on Wednesday 10th of February 2016 08:51:09 AM
Old 02-10-2016
Hashsums and collisions

are collisions less or more likely to occur if you use compressed (ascii) file?
 

3 More Discussions You Might Find Interesting

1. UNIX for Advanced & Expert Users

Solving the network collisions in Unix box

Hi, Anyone can u give me an idea to clear the network collisions in the unix box(Solaris and Linux)? NIC performance is very low, and it shows collisions, when issuing the command ifconfig -a in the production server. How can i rectify the network collisions in the box. Using netstat and lsof... (4 Replies)
Discussion started by: muthulingaraja
4 Replies

2. IP Networking

Acceptable collisions

Hi All I have a Sun V120 with eri0 NIC set to 10-Half connected to Fa0/0 on a Cisco 2600 (Fa0/0 also set to 10-Half). I am seeing collisions on this link (as expectd with a 10-Half connection) BUT, what is an acceptable rate of collisions for this type of link? FYI, the Sun box is showing... (2 Replies)
Discussion started by: bashdem
2 Replies

3. AIX

interface collisions on ethernet nic

Hi, is there any method to check the interface collisions on ethernet NIC in AIX. I know that in Solaris it's netstat -i but I've written that in AIX it doesn't show this. Thanks&regards, p (1 Reply)
Discussion started by: pitmod
1 Replies
fiocompress(1M) 					  System Administration Commands					   fiocompress(1M)

NAME
fiocompress - file compression utility SYNOPSIS
/sbin/fiocompress -c [-m] [-b block_size] input_file output_file /sbin/fiocompress -d input_file output_file DESCRIPTION
The fiocompress utility is a file compression tool that works together with the dcfs(7FS) file system to perform per-file compression. You can use fiocompress to decompress a compressed file or mark a compressed file as compressed, causing automatic decompression on read. The primary use of fiocompress is to compress files in the boot archive. Note that this utility is not a Committed interface. See attributes(5). OPTIONS
The following options are supported: -b block_size Specify a block size for compression. The default block size is 8192. -c Compress the specified file. -d Decompress the specified file. -m Mark the compressed file for automatic decompression on read. Can be used only in conjunction with -c. EXIT STATUS
0 The command completed successfully. -1 The command exited due to an error. ATTRIBUTES
See attributes(5) for descriptions of the following attributes: +-----------------------------+-----------------------------+ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | +-----------------------------+-----------------------------+ |Availability |SUNWcsr | +-----------------------------+-----------------------------+ |Interface Stability |Private | +-----------------------------+-----------------------------+ SEE ALSO
boot(1M), bootadm(1M), dcfs(7FS), ufs(7FS), attributes(5) NOTES
This compression/decompression utility works only with files stored in a UFS file system. There is no obvious way to determine whether a given file is compressed, other than copying the file and comparing the number of disk blocks of the copy against the original. SunOS 5.11 10 Dec 2008 fiocompress(1M)
All times are GMT -4. The time now is 06:22 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy