Hmmmmm.......that's a good question (and although I've done a lot of work on legacy zones, I don't have one here right now). So I'll just give you my thoughts and you'll have to test them.
If there's a legacy zone (Solaris 8 or 9) running under Solaris 10 (since legacy is not supported under Solaris 11), then it must be whole root since it cannot share the system files with the global. Also, the legacy could be assigned an exclusive network interface for its use, or could share one with the global. I would expect sharing to be indicated by the interface showing as eg, hme0:1, hme0:2, and so on. That might tell you something.
Also, whilst even logged into the legacy as root I would expect commands such as 'format', 'prtdiag', and 'cfgadm' to fail with something like "you don't have the rights to do this" type message.
I would expect:
to output something like 'Generic' if the machine was not a physical box.
Just a few thoughts and pointers. I'll give it a go myself when I can.
Hi,
I have a primary/slave Bind 9 setup running on a Solaris 10 platform. Everything is hunky dorey, except for when I make a zone file change and up the serial the file that is transferred to the slave looses all its comments, and the entries are place in alphabetical order.
I administer many... (1 Reply)
Hi All ,
I try to install some packages in my global zone...
On the execution of the installion of the script it quits by saying the error
"Non global zone check failed"
Kindly help me in this regard
Thanks in advance,
jeganr (7 Replies)
I lost my notes on the subject, but I remember running across a single Solaris command that tells you the following
Global zone vs local zone
Sparse local zone vs Whole Root local zone
Can anyone advise? Thanks-In-Advance!! (2 Replies)
Hi Greetings...
I have an issue in connecting the zone from outside the network and it is because of default gateway. I can ping default gateway from inside the zone and not able to ping from global zone due to different VLAN issue. If i add two different gateways and restart network services,... (2 Replies)
I have two physical servers, with zones that mount local storage.
We were using "raw device" in the zonecfg to point to a metadevice on the global zone (it was not mounted in the global zone at any point).
It failed to mount on every boot because the directory existed in the zone.
I... (6 Replies)
can some one help me out as it is showing 2 different time zones in global zone and nonglobal zone .In global zone it is showing in GMT while in nonglobal zone i it showing as PDT.
System in running with solaris 10 (3 Replies)
So this is Solaris 11.1. I have a Global zone that has several non-global zones running in it. I want to change the capped-memory.physical resources setting in ALL the zone configs of the running zones.
if I were to do this manually here's what I would do:
zonecfg -z zone1
select... (2 Replies)
Dear all,
recently, I migrated a solaris zone from one host to another. The zone was inside of a zpool. The zpool cotains two volumes.
I did the following:
host1:
$ zlogin zone1 shutdown -y -g0 -i0 #Zone status changes from running to installed
$ zpool export zone1
host2:
$ zpool... (2 Replies)
Hi, hoping someone can help, its been a while since I used Solaris.
After creating a NGZ (non global zone), the NGZ can access the GZ (Global Zone) and the GZ can access the NGZ (using ssh, zlogin)
However, the NGZ cannot access any other netwqork devices, it can't even see the default router
... (2 Replies)