Ldom problem Post: 302962251

7 More Discussions You Might Find Interesting

1. Solaris

Autosys on LDOM

Has anyone configured an Autosys server to run on a Solaris LDOM? I can't think of any obvious reason why there would be a problem with it, but.... Jerry

2. AIX

ldom and lpar

hi, Plz let me know if the concept of sun ldom and aix lpar is same or not. thnx, snj

3. Solaris

ldom and zone

hi, what is the difference between ldom and zone. can we install any other os than sun in ldom. thanks, snj.

4. Solaris

Has any one installed and used VxVM5.1 in a Ldom .. i was able to install it but when i try to initialize a disk it gives me following error as the disks are imported from ZFS backend .. :-( and they does not show the target no. /etc/vx/bin/vxdisksetup -if c0d2s2 VxVM vxdisksetup ERROR...

5. Solaris

ldom patching

Greetings everyone! I have the task of patching six ldoms and two control domains. I have never done this before and would like to know of any pitfalls or "gotchas" I may encounter. I have been looking online but have found very little about patching ldoms. Thank you all.

6. Solaris

ZFS LDOM problem on Solaris 10

Apologies if this is the wrong forum.. I have some LDOMs running on a Sparc server. I copied the disk0 file from one chassis over to another, stopped the ldom on the source system and started it on the 2nd one. All fine. Shut it down and flipped back. We then did a fair bit of work on the...

7. Solaris

Ldom guest volumen problem t8 Solaris 11

hello to everyone. im new member here. i have a problem with a guest ldom on solaris 11 sparc in a T8. I need to access to disk vds assigned to guest domain but from control domain. I want to modify a parameter in inittab of the guest domain because start guest domain give me problems...

LEARN ABOUT DEBIAN

kumoctl

KUMOCTL(1)						      General Commands Manual							KUMOCTL(1)

NAME

       kumoctl - show kumofs status

SYNOPSIS

       kumoctl address[:port=19750] command [options]

DESCRIPTION

       Show status of kumo-manager and send control commands to kumo-manager.

COMMANDS

       status show status of the cluster

       attach attach all new servers and start replace

       attach-noreplace
	      attach all new servers

       detach detach all fault servers and start replace

       detach-noreplace
	      detach all fault servers

       replace
	      start replace without attach/detach

       full-replace
	      start full-replace (repair consistency)

       backup [suffix=20090304]
	      create backup with specified suffix

       enable-auto-replace
	      enable auto replace

       disable-auto-replace
	      disable auto replace

STATUS

       hash space timestamp
	      The  time  that the list of attached kumo-servers is updated. It is updated when new kumo-server is added or existing kumo-server is
	      down.

       attached node
	      The list of attached kumo-servers. (active) is normal node and (fault) is fault node or recoverd but not re-attached node.

       not attached node
	      The list of recognized but not-attached nodes.

AUTO REPLACING

       By default, you have to attach new kumo-servers manually using kumoctl command. If the auto replacing  is  enabled,  new  kumo-servers  are
       attached automatically.	This is experimental feature.

EXAMPLE

       $ kumoctl mgr1 status

       $ kumoctl mgr1 attach

SEE ALSO

       kumo-manager(1).

kumoctl 							     July 2009								KUMOCTL(1)