How do I interface with pf in a C/C++ application? Post: 302951388

Sponsored Content

Top Forums UNIX for Advanced & Expert Users How do I interface with pf in a C/C++ application? Post 302951388 by nactusberrilli on Wednesday 5th of August 2015 10:36:44 PM

08-05-2015

Registered User

How do I interface with pf in a C/C++ application?

I'd like to write a simple GUI C/C++ application (a simple interface) where the user can perform a few pf operations and also receive pf feedback (instead of using the pfctl command). I was hoping to get some guidance in regards to where to get started. The pf suggests the use of the ioctl interface . I can see a bunch of constants that start with "DIOC". A quick example or a tutorial on how to get started developing with pf would be more than appreciated. Thanks.

nactusberrilli

View Public Profile for nactusberrilli

Find all posts by nactusberrilli

3 More Discussions You Might Find Interesting

1. Solaris

Command line Interface or GUI Interface not shown on solaris

Dear all, I am a newbie in solaris and I need your advice. I have a Solaris version 5.9 installed on Sunfire V240. I am able to ssh the machine from putty remotely. My problem is that I cannot see the display from KVM switch I have connected to it. I need also to be able to see the GUI...

2. SCO

Change SCO - GUI or Desktop interface to DOS based interface

Hi all I have installed a demo version of SCO OpenServer 5.0.2, I finally found it is Desktop Interface, I would like to know how to change its interface to dos based interface? If you have any ideas, please tell me then. Thank you

3. IP Networking

Need a bridge from an ethernet interface to a serial interface

This is my situation DOS pc serial cable (sl0) Linux Pc eth1 192.168.0.10 <-------------------->192.168.0.2 <------------>192.168.0.1 (router) I connected the linux pc and the dos pc with a SLIP (serial line internet protocol), so they can communicate in the sl0 interface. ...