QLXGBE(4)						   BSD Kernel Interfaces Manual 						 QLXGBE(4)

NAME

     qlxgbe -- QLogic 10 Gigabit Ethernet & CNA Adapter Driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel configuration file:

	   device qlxgbe

     To load the driver as a module at boot time, place the following line in loader.conf(5):

	   if_qlxgbe_load="YES"

DESCRIPTION

     The qlxgbe driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4
     and IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling.  For further hardware information, see http://www.qlogic.com/.

HARDWARE

     The qlxgbe driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets:

     o	 QLogic 8300 series

SUPPORT

     For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at
     <support@qlogic.com>.

SEE ALSO

     altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY

     The qlxgbe device driver first appeared in FreeBSD 10.0.

AUTHORS

     The qlxgbe driver was written by David C Somayajulu at QLogic Corporation.

BSD
								   April 1, 2013							       BSD