I am not very savvy with Solaris but am responsible for a server running Solaris 10 that has a failed hard drive in a mirrored pool. I ordered a new drive and attempted to install but received the error "device too small" when using zpool replace. The drive is the same Seagate model number as the old one and has the same nominal capacity of 300GB. Here's what prtvtoc says about the disks. Note that c1t0d0s2 is the new drive.
From what I read, I understand that a mirrored pool cannot shrink. So since I'm not really familiar with all of this, I ask why cant I just create a new pool? Can this be done without loosing the data on c1t1d0s2?
Please help me!!!. I am new to Unix and I have to replace the tape backup drive. Originally the system had an IBM tape drive (Rhomat) that is damged. I changed it and installed a dat drive HP 5000+. The hardware recognize the drive, the diagnostics if OK. But when I try to install the operating... (3 Replies)
Hi folks,
I have the following configuration file:
tofu:/tmp # cat bitbandConfig.properties
maestroIp=10.10.10.10
maestroPort=2020
adminPlayPath=<Streaming Agent IP>:2021/streamingGateway/GetPlayList
###This part should not be changed###
adminPlayVODProtocol=http
username=iptv... (7 Replies)
My root disk is failed and how to replace the root disk in AIX.
Can u give a detailed explanation in step wise.
Pls give the answer taking different scenarios.
Regards
Praveen (1 Reply)
Any help appreciated
Sco Unix Ver 5.0+
Have 2 90 gig mirrored drives
Can these be replaced with any similar drive?
Can one just be replaced and will the mirror rebuild on it and then allow reboot on it ---then replace 2nd drive?
Thanks
pb (3 Replies)
I am trying to recover data off a drive that failed in my iMac. Apple returned the drive to me and I purchased a hard drive enclosure. I have been doing research on prices for data recovery services, way too expensive. I seen some links using Unix DD commands in the terminal none of which worked.... (6 Replies)
I am new to the AIX operating system and am seeking out some advice. We recently have had a drive go bad on our AIX server that is in a RAID 10 array. We have a replacement on the way. I was wondering what the correct steps are to swap out this drive. Does the server need to be powered off? Or can... (5 Replies)
I have a AIX 7.1 system that has 3 failed disks, 1 in rootvg and 2 in vg_usr1.
Here is the output of lspv.
# lspv
hdisk0 00044d4dfbb11575 vg_usr1 active
hdisk1 0000150179158027 vg_usr1 active
hdisk2 ... (11 Replies)