Sponsored Content
Special Forums Hardware Filesystems, Disks and Memory MDADM Failure - where it came from? Post 302926781 by Sunghost on Thursday 27th of November 2014 04:24:34 AM
Old 11-27-2014
Kernel Version

Hello,
its the amd64 kernel from debian wheezy backports 3.16. i think its a problem with the marvel chipset. i found some other who have those problems in the net, but i am not sure.
 

10 More Discussions You Might Find Interesting

1. Programming

ld failure

Hi, I am using gmake to compile a c program with a makefile. The make file runs ld. I get the following error jsh1035c:/users/egate453/admegate/kapil/samples $ gmake -e -f GNUmakefile queue_c gmake -f ./GNUmakefile queue_c in_objdir=1 build_root=/users/egate453/admegate/kapil/samples... (2 Replies)
Discussion started by: handak9
2 Replies

2. Linux

mdadm - Swapping 500GB disks for 1TB

Hi, I have a three disk raid 5, with 500GB disks. This is close to being full, and whilst I can just add another disk and rebuild to add another 500GB, I would prefer to replace with 1TB disks. So i have some questions. Can I replace these disks one by one with bigger disks? I... (1 Reply)
Discussion started by: snoop2048
1 Replies

3. Virtualization and Cloud Computing

is mdadm --incremental --rebuild --run --scan destructive?

Hello Unix Community: My task to figure out how to add a 20G volume to an existing EBS Array (RAID0) at AWS. I haven't been told that growing the existing volumes isn't an option, or adding another larger volume to the existing array is the way to go. The client's existing data-store is... (0 Replies)
Discussion started by: Habitual
0 Replies

4. Emergency UNIX and Linux Support

mdadm unable to fail a resyncing drive?

Hi All I have a RAID 5 array consisting of 4 drives that had a partial drive failure in one of the drives. Rebooting shows the faulty drive as background rebuilding and mdadm /dev/ARRAYID shows three drives as in sync with the fourth drive as spare rebuilding. However the array won't come... (9 Replies)
Discussion started by: Bashingaway
9 Replies

5. UNIX for Advanced & Expert Users

mdadm question

Hello, I have 4 drives (500G each) in a raid 10, I got a power failior and this is the result? cat /proc/mdstat Personalities : md126 : inactive sdb sdc sdd sde 1953536528 blocks super external:-md127/0 md127 : inactive sdd(S) sde(S) sdb(S) sdc(S) 9028 blocks super... (3 Replies)
Discussion started by: rmokros
3 Replies

6. UNIX for Advanced & Expert Users

mdadm container! How does it work

Hi everyone, I am not sure if I understand how mdadm --create /dev/md0 --level=container works? A device called /dev/md0 appears in /proc/mdstat but I am not sure how to use that device? I have 2 blank drives with 1 500GB partition on each. I would like to setup mirroring, but not in the... (0 Replies)
Discussion started by: hytron
0 Replies

7. Red Hat

mdadm for / and /boot

had this RHEL 5 installation with /dev/sda1 and /dev/sda2 running.. created two more partitions /dev/sdj1 and /dev/sdj2 , the same sized partition as /dev/sda trying to use mdadm to create RAID1 .. I cannot even do it in "rescue" mode, I wonder if it can be done.. it kept... (2 Replies)
Discussion started by: ppchu99
2 Replies

8. UNIX for Dummies Questions & Answers

boot up failure unix sco after power failure

hi power went out. next day unix sco wont boot up error code 303. any help appreciated as we are clueless. (11 Replies)
Discussion started by: fredthayer
11 Replies

9. UNIX for Advanced & Expert Users

USB RAID 5 Problem on Joli OS 1.2 (Ubuntu) using mdadm

Hi All, I have been trying to create a USB RAID 5 using mdadm tool on Joli OS 1.2 (Ubuntu) but with no luck. I cannot even get pass the creation of array device (/dev/md0) and superblock. I am using 3 USB keys (2 16.4 GB kingston and 1 16GB sandisk). My steps are: ... (5 Replies)
Discussion started by: powelltallen
5 Replies

10. UNIX for Advanced & Expert Users

How to fix mistake on raid: mdadm create instead of assemble?

Hi guys, I'm new to RAID although I've had a server running raid5 for a while. It was delivered preinstalled like this and I never really wondered how to monitor and maintain it. This quick introduction just to let you understand why I'm such an idiot asking such a silly question. Now what... (0 Replies)
Discussion started by: chebarbudo
0 Replies
usba(7D)																  usba(7D)

NAME
usba, usb - Solaris USB Architecture (USBA) USB provides a low-cost means for attaching peripheral devices, including mass-storage devices, keyboards, mice, and printers, to a system. For complete information on USB, go to the USB website at http://www.usb.org. USBA supports 126 hot-pluggable USB devices per USB bus. The maximum data transfer rate is 1.5 Mbits (low speed USB 1.x) or 12 Mbits (full speed USB 1.x) or 480 MBits (high speed USB 2.0) Mbits per second (Mbps). USBA adheres to the Universal Serial Bus 2.0 specification and provides a transport layer abstraction to USB client drivers. FILES
Listed below are drivers and modules which either utilize or are utilized by USBA. Drivers in /kernel/drv are 32 bit drivers ( only). Driv- ers in /kernel/drv/sparcv9 or /kernel/drv/amd64 are 64 bit drivers. +------------------------------------+----------------------------------+ | CLIENT DRIVER | FUNCTION/DEVICE | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]hid | HID class | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]hubd | hub class | +------------------------------------+----------------------------------+ |/ker- | mass storage class | |nel/drv/[sparcv9|amd64/]scsa2usb | | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]usbprn | printer class | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]usb_as | audio streaming class | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]usb_ac | audio control class | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]usb_mid | multi-interface device | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]usb- | Edgeport USB to serial port | |ser_edge | | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]ugen | generic USB driver | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]ohci | open host controller driver | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]uhci | universal host controller driver | +------------------------------------+----------------------------------+ |/kernel/drv/[sparcv9|amd64/]ehci | enhanced host controller driver | +------------------------------------+----------------------------------+ +--------------------------------+-----------------------------+ | CLIENT STREAMS MODULES | FUNCTION/DEVICE | +--------------------------------+-----------------------------+ |/kernel/strmod/[sparcv9/]usbkbm | Keyboard | +--------------------------------+-----------------------------+ |/kernel/strmod/[sparcv9/]usbms | Mouse | +--------------------------------+-----------------------------+ |/kernel/strmod/[sparcv9/]usb_ah | audio HID | +--------------------------------+-----------------------------+ +------------------------------------------+----------------+ | HOST CONTROLLER INTERFACE DRIVERS | DEVICE | +------------------------------------------+----------------+ |/kernel/drv/[sparcv9/]ehci | Enhanced HCI | +------------------------------------------+----------------+ |/kernel/drv/[sparcv9/]ohci | Open HCI | +------------------------------------------+----------------+ |/kernel/drv/[sparcv9/]uhci | Universal HCI | +------------------------------------------+----------------+ See attributes(5) for a description of the following attributes: +-----------------------------+-----------------------------+ | ATTRIBUTE TYPE | ATTRIBUTE VALUE | +-----------------------------+-----------------------------+ |Architecture |PCI-based systems | +-----------------------------+-----------------------------+ |Availability |SUNWusb | +-----------------------------+-----------------------------+ cfgadm_usb(1M), attributes(5), ehci(7D), hid(7D), hubd(7D), ohci(7D), scsa2usb(7D), uhci(7D), usb_ac(7D), usb_as(7D), usb_mid(7D), usbprn(7D), usbser_edge(7D), ugen(7D), virtualkm(7D) Universal Serial Bus Specification 2.0. System Administration Guide: Basic Administration http://www.sun.com/io NOTES
Booting from USB mass-storage devices is not supported. The messages described below may appear on the system console as well as being logged. All messages are formatted in the following manner: WARNING: Error message... No driver found for device <device_name> (interface <number> node name=<node_name>) The installed Solaris software does not contain a supported driver for this hardware. <number> is the interface number. <name> is either the device path name or the device name. Draining callbacks timed out! An internal error occured. Please reboot your system. If this problem persists, contact your system vendor. 27 June 2005 usba(7D)
All times are GMT -4. The time now is 01:16 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy