11-14-2014
Hi, This error was while installing DAQ...
I just run ./configure in the DAQ directory.
7 More Discussions You Might Find Interesting
1. UNIX for Advanced & Expert Users
i'm following the, "How to setup and secure Snort, MySQL and Acid on FreeBSD 4.6 Release" off of the snort.org website.
in the documentation it says snort should be installed through the following:
-----
make -DWITH_MYSQL -DWITH_FLEXRESP ; make install
-----
later it says to do the... (13 Replies)
Discussion started by: xyyz
13 Replies
2. BSD
Im trying to gather some info to set up snort on openbsd 3.2, has anyone out there managed to get it up and running ? My initial attempts seem to be quite below par (4 Replies)
Discussion started by: malcontent
4 Replies
3. Linux
Hi,
can anybody know snort port no in linux, (1 Reply)
Discussion started by: manoj.solaris
1 Replies
4. Cybersecurity
I have been asked to place 2 (1 NTOP & 1 SNORT) boxes within our network as part of our tool kit for network monitoring and Intrusion detection. Out network is very simplistic and it layed out like this:
internet
|
|
Cisco 1811 Router (8x Layer 2 switch ports)
... (0 Replies)
Discussion started by: metallica1973
0 Replies
5. Cybersecurity
Is it possible to rule out in alert all HTTPS traffic or rule out all the HTTPS trafic from the alerts on snort ? (3 Replies)
Discussion started by: drd0spt
3 Replies
6. Solaris
Not very helpful to say the least. Seems to read the flar file and go through the upgrade and then come up with this error.
Any ideas? (1 Reply)
Discussion started by: psychocandy
1 Replies
7. UNIX for Beginners Questions & Answers
I've been trying to get Snort running on my lab network, but haven't been having much luck.
I installed Snort 2.9.14 on both Windows 10 & Ubuntu 18.04 (Running in VirtualBox 5.2.22). I seems to have the snort.conf file set up correctly in both environments, because when I test snort in either... (1 Reply)
Discussion started by: bodisha
1 Replies
LEARN ABOUT DEBIAN
dh_auto_configure
DH_AUTO_CONFIGURE(1) Debhelper DH_AUTO_CONFIGURE(1)
NAME
dh_auto_configure - automatically configure a package prior to building
SYNOPSIS
dh_auto_configure [buildsystemoptions] [debhelperoptions] [--params]
DESCRIPTION
dh_auto_configure is a debhelper program that tries to automatically configure a package prior to building. It does so by running the
appropriate command for the build system it detects the package uses. For example, it looks for and runs a ./configure script,
Makefile.PL, Build.PL, or cmake. A standard set of parameters is determined and passed to the program that is run. Some build systems, such
as make, do not need a configure step; for these dh_auto_configure will exit without doing anything.
This is intended to work for about 90% of packages. If it doesn't work, you're encouraged to skip using dh_auto_configure at all, and just
run ./configure or its equivalent manually.
OPTIONS
See "BUILD SYSTEM OPTIONS" in debhelper(7) for a list of common build system selection and control options.
-- params
Pass params to the program that is run, after the parameters that dh_auto_configure usually passes. For example:
dh_auto_configure -- --with-foo --enable-bar
SEE ALSO
debhelper(7)
This program is a part of debhelper.
AUTHOR
Joey Hess <joeyh@debian.org>
9.20120909 2011-10-19 DH_AUTO_CONFIGURE(1)