What RJ11 Cables Should I Use? Post: 302916917

7 More Discussions You Might Find Interesting

1. Solaris

Scsi cables - which ones?

Is there any specific scsi cables that you need to get when connecting a tape drive or external storage or does one type of cable fit all? ie. I can buy the following: HD68 to HD68 with Ferrites supports S-E Ultra/Wide transfer rates. But will this work for tape drives and storage? I...

2. IP Networking

fc cables

hi friends, we are using fc cables and fc switches,u might be aware of the cost factor of it so just wanted to know that Why do we need FC switches and fiber-optic cables? Is it not possible to use, say, twisted-pair copper cables instead of fiber-optic cables, and achieve almost comparable...

3. Solaris

pinout DB9 to RJ11 of T3 Array Disk?

Hello friends, i have a problem with the pinout of T3 Array Disk cuz i don't know to build this serial cable :( please anybody help me!

4. Solaris

1 or 2 Fiber cables?

Hi Community, I'm working on Solaris 10 installation with 1 Server V490 and 1 StoredgeTek 3510 (Standalone configuration). I'd connect the Server to the Storedge with a fiber cable but I' m in doubt becouse I don't know if using 1 or 2 fiber cable. Could you provide me any solution? ...

5. Solaris

SUNFIRE V240 procedure to shutdown with safety in order to replace power cables

Question: Which commands to use to shutdown with safety the server;

6. Hardware

Flat cables vs normal circular cables

Do flat cables have any advantage over normal circular cables? I was looking at this. 6ft 2M Flat USB Sync Data Cable Charger Cord for iPhone4 4S 3G iPad1 2 3 Orange | eBay

7. War Stories

Following Cables for Fun!

Hi Folks, I came accross this picture taken a number of years ago now, I just thought I'd share it with you guys. We were in the process of removing equipment from the Data Centre and had followed the cable through to this area, where one of the old patch areas had been. When we lifted the...

LEARN ABOUT X11R4

liebert

LIEBERT(8)							    NUT Manual								LIEBERT(8)

NAME

       liebert - Driver for Liebert contact-closure UPS equipment

NOTE

       This man page only documents the hardware-specific features of the liebert driver. For information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

       This driver supports some Liebert UPS equipment with a contact-closure interface. This includes the UPStation GXT2 with their
       contact-closure cable. The smart mode ("Multilink") cable is not supported by this driver.

EXTRA ARGUMENTS

       This driver does not support any extra settings in the ups.conf(5).

BUGS

       This driver does not yet support shutdowns by raising DTR. Be aware that shutdowns are not possible with the stock contact-closure cable.
       You may have to build another cable with DTR connected through to the UPS for it to work.

       There is no way for this driver to detect the hardware or cable. It will start up successfully even if no UPS is present. This is a
       fundamental limitation of any contact-closure driver.

SEE ALSO

   The core driver:
       nutupsdrv(8)

   Internet resources:
       The NUT (Network UPS Tools) home page: http://www.networkupstools.org/

Network UPS Tools						    05/21/2012								LIEBERT(8)