09-02-2014
VirtualBox
I want to change my virtual box disk to immutable. When I try to do that I get the following error.
Error changing medium type from Normal to Immutable.
Cannot change the type of medium '/root/VirtualBox VMs/fedora13/fedora13.vmdk' because it is attached to 1 virtual machines
Please help me how to resolve this. My host system is RHEL 5.6
Last edited by fpmurphy; 09-02-2014 at 10:54 PM..
4 More Discussions You Might Find Interesting
1. Solaris
I've just installed VirtualBox on my PC and installed OpenSolaris as a virtual machine within it. The PC connects to the internet via a router and uses DHCP to get its IP address. How do I configure the OpenSolaris virtual machine to use the same DHCP server so I can connect it to the net. At the... (4 Replies)
Discussion started by: JerryHone
4 Replies
2. Virtualization and Cloud Computing
Hello, guys!
I use Ubuntu 9.04 as desktop operating system and I want to make some tests on NetBSD. I tried to install as a virtual sistem on VirtualBox but it doesn't want to install. You can see the error in the attached file.
Do you guys have any clue about what the problem could be? (3 Replies)
Discussion started by: Sergiu-IT
3 Replies
3. SCO
Has anyone installed SCO 6 in Virtualbox? I was quite successful with 5.0.6 but then when I tried SCO 6, it will not report any nic (I am using resmgr to see who is there). The available cards under virtualbox are pcnet-pci II and II, and a few intel/pro 1000s. I have installed the maintenance pack... (1 Reply)
Discussion started by: dalek
1 Replies
4. IP Networking
Hello;
Please,I did the clone on virtualBox, but the machines have the same IP address: eth2 Link encap: Ethernet HWaddr 8:00:27: f0: 92:19 inet addr: 192.168.1.4 Bcast: 192.168.1.255 Mask: 255.255.255.0
how to change the address please?
Thank you so much (6 Replies)
Discussion started by: chercheur857
6 Replies
EJECT(1) BSD General Commands Manual EJECT(1)
NAME
eject -- eject a floppy disk, cdrom or tape
SYNOPSIS
eject [-fv] [-l | -L | -U] [-t device-type] [-d] device
eject -n
DESCRIPTION
The eject program ejects a medium from the specified device. It can also load a cdrom in the drive if this operation is supported by the
hardware. The device argument specifies a device either by its full path name (identified by a /dev/ prefix), or by one of the built-in
nicknames. If the medium contains a file system that is currently mounted, eject will attempt to unmount the file system before ejecting.
The following options are available:
-d Deprecated.
-f Force the eject operation without attempting to unmount any file systems first.
-l Load media in the drive (only supported for the cdrom device type).
-L Lock the media into the drive (but see BUGS below).
-n List the built-in nicknames on standard output.
-t device-type
Specify the device type. The argument must be one of diskette, floppy, cdrom, disk, or tape. This option is necessary when ejecting a
device for which no built-in knowledge is available.
-U Unlock the media from the drive.
-v Display some of the actions taken on standard output.
BUGS
Most disk drivers automatically lock the media on the first open and unlock it on the last close, making 'eject -L' almost useless, since
when it closes the device, it gets unlocked again.
BSD
October 6, 2001 BSD