1)for hardware clock, I will use cmd :
2) Setting System timing to according to Hardware timing:
or
Please advice either hardwae to system timing copy will be ok or system to hardware timing ok?
3) We have already set the time zone so I will not change it.
4) We have some application running over these system where server1 is master and server2 as slave. kindly also advice that we need to stop out application or without stopping, we can proceed for time change?
5)I checked on the internet and mentiond like hardware clock always keep running even after the server is in shutdown status while system clock depends on kernal. once linux OS is shutdwon then system clock stop running.
Kindly Advice...
Last edited by Franklin52; 06-05-2014 at 11:10 AM..
Reason: Please use code tags
having problems using scp in that during peak hours it appears to time out.
anyone have similar experiences? any thoughts regarding a solution... (1 Reply)
hi everyone. If you have a function created in your code and you want to find out how long it takes for it to run you can use a struct called gettimeofday().
so lets say we have a function like this
int myfunction (int r)
{
/*some math calculations*/
return answer;
}
How do i set up... (3 Replies)
hi all,
i want to setup a solaris10 lab for 50 trainees. kindly let me know all the basic hardware & system requirements for the lab .
with regards,
Raj (5 Replies)
hello everybody,
Is there any training to get deep knowledge an hands on lab with system p hardware firmware microcode upgrading etc... thanks in advance (2 Replies)
i have a very big script i have that i'd like to add a timeout to.
this script runs on a several remote host. i update this script with timeout clause and then copy it over to all the hosts on which it is currently on.
basically, i want the timeout to make the script abort/exit if it's... (1 Reply)
Hi All,
Can someone let me know the method or set of commands by which i can retrive manufacturer name of computer system (hardware of machine ) and manufacturer of processor. i get below information when fired psrinfo command :
psrinfo -vp
The physical processor has 1 virtual processor... (6 Replies)
Hello guys.
I wanted to find the System Configuration and Hardware Information on one of my servers. Here is part of the cpu info:
CPU core info:
processor : 0
vendor_id : GenuineIntel
cpu family : 6
model : 44
model name : Intel(R) Xeon(R) CPU... (2 Replies)
We have a legacy software application that runs on SCO OpenServer 5.0.6, and the current server (built around 2003-04) is still running. I have been attempting to upgrade the hardware, to hopefully increase the time that we will have access to the data in this system, but am running into an... (13 Replies)