Hi ,
I have one system installed on Linux Red Hat 3.0. I have ip of system 3.156.168.*** and i want to ping some port that is on this IP which command i can do this?
sam70 (1 Reply)
Hi All,
Need your help one more time.
I am trying to ping a linux machine which is not responding to ping.
However traceroute can reach the machine and I can log in to it by ssh. I have checked /proc/sys/net/ipv4/icmp_echo_ignore_all it is already set as "0".
It is not happening in the... (1 Reply)
I have an old MP-Ras Unix system. I have setup netowkring but am unable to ping any local network pcs or the default gateway. If i use the arp -a command I receive the correct mac address for all connected pcs but I cannot ping anything except the local address. Any help would be appreciative.
... (7 Replies)
Hi,
I develop simple animation ping script on Solaris Platform. It is like Cisco ping.
Examples and source code are below.
bash-3.00$ gokcell 152.155.180.8 30
Sending 30 Ping Packets to 152.155.180.8
!!!!!!!!!!!!!.!!!!!!!!!!!!!!!.
% 93.33 success... % 6.66 packet loss...... (1 Reply)
I am unable to ping my remote server.My server is unable to ping the same. both are able to ping the gateway. both the ip's are on same network.i use a proxy tunnel on my remote server.Help if any clues. (6 Replies)
SHAME, that's all that I'm felling right now, however I'm not finding PING or either tracert in my box (Solaris 10).
1) Yes my PATH does have /usr/bin /usr/sbin
# echo $PATH
/opt/csw:/usr/bin:/sbin:/usr/sbin:/usr/ccs/bin:/usr/sfw/bin:/opt/csw/bin:/opt/csw/gcc2/bin:/opt/csw/bin
2) If I... (1 Reply)
Hi
I am using perl to ping a list of nodes - with script below :
$p = Net::Ping->new("icmp");
if ($p->ping($host,1)){
print "$host is alive.\n";
}
else {
print "$host is unreacheable.\n";
}
$p->close();... (4 Replies)
This is a small program as a tester for a basic sweep generator for bandwidth testing of AudioScope.sh.
This DEMO is only capable of 4KHz down to about 85Hz and back due to the low bit rate, but it is proof of concept for a much wider variant using a much higher bit rate.
The file generated... (4 Replies)
help with bash script!
im am working on this script to make sure my server will stay online, so i made this script..
HOSTS="192.168.138.155"
COUNT=4
pingtest(){
for myhost in "$@"
do
ping -c "$COUNT" "$myhost" &&return 1
done
return 0
}
if pingtest $HOSTS
#100% failed... (4 Replies)
Discussion started by: mort3924
4 Replies
LEARN ABOUT SUSE
arping
ARPING(8) System Manager's Manual: iputils ARPING(8)NAME
arping - send ARP REQUEST to a neighbour host
SYNOPSIS
arping [ -AbDfhqUV] [ -c count] [ -w deadline] [ -s source] -I interface destination
DESCRIPTION
Ping destination on device interface by ARP packets, using source address source.
OPTIONS -A The same as -U, but ARP REPLY packets used instead of ARP REQUEST.
-b Send only MAC level broadcasts. Normally arping starts from sending broadcast, and switch to unicast after reply received.
-c count
Stop after sending count ARP REQUEST packets. With deadline option, arping waits for count ARP REPLY packets, until the timeout
expires.
-D Duplicate address detection mode (DAD). See RFC2131, 4.4.1. Returns 0, if DAD succeeded i.e. no replies are received
-f Finish after the first reply confirming that target is alive.
-I interface
Name of network device where to send ARP REQUEST packets. This option is required.
-h Print help page and exit.
-q Quiet output. Nothing is displayed.
-s source
IP source address to use in ARP packets. If this option is absent, source address is:
o In DAD mode (with option -D) set to 0.0.0.0.
o In Unsolicited ARP mode (with options -U or -A) set to destination.
o Otherwise, it is calculated from routing tables.
-U Unsolicited ARP mode to update neighbours' ARP caches. No replies are expected.
-V Print version of the program and exit.
-w deadline
Specify a timeout, in seconds, before arping exits regardless of how many packets have been sent or received. In this case arping
does not stop after count packet are sent, it waits either for deadline expire or until count probes are answered.
SEE ALSO ping(8), clockdiff(8), tracepath(8).
AUTHOR
arping was written by Alexey Kuznetsov <kuznet@ms2.inr.ac.ru>.
SECURITY
arping requires CAP_NET_RAWIO capability to be executed. It is not recommended to be used as set-uid root, because it allows user to modify
ARP caches of neighbour hosts.
AVAILABILITY
arping is part of iputils package and the latest versions are available in source form for anonymous ftp ftp://ftp.inr.ac.ru/ip-rout-
ing/iputils-current.tar.gz.
iputils-021109 09 iINAON 2002 ARPING(8)