sco unix 5.0.x, several weeks ago, I add a telnet-like service in inetd.conf, it runs well for 100 network terminals.
But nowdays, the terminals can connect to server successfully after booting machine, but several hours later, can not connect. "netstat -p tcp -a" can NOT find the port in... (1 Reply)
Discussion started by: shark_gao
1 Replies
2. Post Here to Contact Site Administrators and Moderators
Dear Administrators,
I think Mr. Vino is one of your Moderators here because he closes this thread: https://www.unix.com/showthread.php?p=302086230#post302086230
without a valid reason.
Rule 7 states no headhunters or recruiters, but career advice is not prohibited here i think, because it... (2 Replies)
Hi folks,
First of all, sorry about my english, isn't the best and thks for advance.
Here es my problem...
I have virtualize an SCO unix with VMware ESX 3 and everything was going on beatifull until that i try to connect from anorther host, i can't do it so i check the connection with... (5 Replies)
Hello,
Actually there are some bugs in application which does not close the TCP connection to other server though CORBA.
We need to kill that ESTABLISHED connections as new connection are not happeneing as the allocated ports were used and showing as ESTABLISHED
Is there any... (4 Replies)
Dear experts,
I am seeing a lot of TCP failed connection attempts from "netstat -s" on one of our servers.
How can I pin point what connection failed and what are the ports involved?
Any tools/commands I can dig in deeper to diag. what went wrong on these "failed connection attempts"?
... (2 Replies)
I've recently installed Solaris 10 10/9 in a new Dell Power Edge 630. Whenever I try to telnet, ssh, or FTP TO this box FROM another box on the same network segment, the following occurs:
Roughly 80% of the time I get "Unable to connect to remote host: Connection refused"
The remaining 20%... (0 Replies)
I have a TCPIP server application (a Vendor package) which by default allows 10 connections. It provides a parameter to allow us to increase the maximum allowable connections in case it is needed. Intermittently this application is failing with maximum number of connections reached even when there... (1 Reply)
Discussion started by: AIX_user
1 Replies
LEARN ABOUT SUSE
lmtpd
LMTPD(8) System Manager's Manual LMTPD(8)
*
NAME
lmtpd - LMTP server process
SYNOPSIS
lmtpd [ -C config-file ] [ -U uses ] [ -T timeout ] [ -D ]
[ -a ]
DESCRIPTION
Lmtpd is an LMTP server used to deliver mail to the IMAP mailstore. It accepts commands on its standard input and responds on its standard
output. It MUST be invoked by master(8) with those descriptors attached to a remote client connection.
Lmtpd reads its configuration options out of the imapd.conf(5) file unless specified otherwise by -C.
OPTIONS -C config-file
Read configuration options from config-file.
-U uses
The maximum number of times that the process should be used for new connections before shutting down. The default is 250.
-T timeout
The number of seconds that the process will wait for a new connection before shutting down. Note that a value of 0 (zero) will dis-
able the timeout. The default is 60.
-D Run external debugger specified in debug_command.
-a Preauthorize connections initiated on an internet socket, instead of requiring LMTP AUTH. This should only be used for connections
coming from trusted hosts.
FILES
/etc/imapd.conf
SEE ALSO imapd.conf(5), master(8)CMU Project Cyrus LMTPD(8)