IWSPY(8)						     Linux Programmer's Manual							  IWSPY(8)

NAME

       iwspy - Get wireless statistics from specific nodes

SYNOPSIS

       iwspy [interface]
       iwspy interface [+] DNSNAME | IPADDR | HWADDR [...]
       iwspy interface off
       iwspy interface setthr low high
       iwspy interface getthr

DESCRIPTION

       Iwspy  is  used to set a list of addresses to monitor in a wireless network interface and to read back quality of link information for each
       of those. This information is the same as the one available in /proc/net/wireless : quality of the link, signal strength and noise level.

       This information is updated each time a new packet is received, so each address of the list adds some overhead in the driver.

       Note that this functionality works only for nodes part of the current wireless cell, you can not monitor Access Points you are not  associ-
       ated  with (you can use Scanning for that) and nodes in other cells. In Managed mode, in most case packets are relayed by the Access Point,
       in this case you will get the signal strength of the Access Point. For those reasons this functionality is mostly useful in Ad-Hoc and Mas-
       ter mode.

PARAMETERS

       You may set any number of addresses up to 8.

       DNSNAME | IPADDR
	      Set  an IP address, or in some cases a DNS name (using the name resolver). As the hardware works with hardware addresses, iwspy will
	      translate this IP address through ARP.  In some case, this address might not be in the ARP cache and iwspy will fail. In those case,
	      ping(8) this name/address and retry.

       HWADDR Set  a hardware (MAC) address (this address is not translated & checked like the IP one). The address must contain a colon (:) to be
	      recognised as a hardware address.

       +      Add the new set of addresses at the end of the current list instead of replacing it. The address list is unique for each device,	so
	      each user should use this option to avoid conflicts.

       off    Remove the current list of addresses and disable the spy functionality

       setthr Set the low and high signal strength threshold for the iwspy event (for drivers that support it).
	      Every time the signal strength for any of the address monitored with iwspy goes lower than the low threshold or goes higher than the
	      high threshold, a Wireless Event will be generated.
	      This can be used to monitor link outages without having to run iwspy periodically.

       getthr Retrieve the current low and high signal strength threshold for the iwspy event.

FILES

       /proc/net/wireless

SEE ALSO

       iwconfig(8), iwlist(8), iwevent(8), iwpriv(8), wireless(7).

net-tools							  31 October 1996							  IWSPY(8)