Sponsored Content
Operating Systems Linux Issue with ethernet interface Post 302889438 by cerco on Thursday 20th of February 2014 02:02:02 PM
Old 02-20-2014
hi rbatte1,
once again thank you for your support.
what I do not understand in fact, it is the fact that I need to add a gateway for the network 10.6.0.0/26. As eth2 (10.6.0.50), is in the network 10.6.0.0 and the other equipment (10.6.0.33), is also in the same network, then what is the reason to add a gateway between them to communicate? I'm sorry but I still do not understand why the gateway is necessary in this case. if you can provide me more clarifications, it will help me a lot.
please find below ifcfg for eth0 and eth2:
Code:
cat /etc/sysconfig/network-scripts/ifcfg-eth0
# Broadcom Corporation NetXtreme II BCM5709 Gigabit Ethernet
DEVICE=eth0
BOOTPROTO=none
HWADDR=BC:30:5B:DD:74:85
ONBOOT=yes
NETMASK=255.255.255.192
IPADDR=10.10.136.10
GATEWAY=10.10.136.1
TYPE=Ethernet
USERCTL=no
IPV6INIT=no
PEERDNS=yes

[root@sigsrv01 ~]# cat /etc/sysconfig/network-scripts/ifcfg-eth2
# Broadcom Corporation NetXtreme II BCM5709 Gigabit Ethernet
DEVICE=eth2
BOOTPROTO=none
HWADDR=BC:30:5B:DD:74:89
ONBOOT=yes
HOTPLUG=no
TYPE=Ethernet
NETMASK=255.255.255.192
IPADDR=10.6.0.50
USERCTL=no
IPV6INIT=no
PEERDNS=yes
[root@sigsrv01 ~]#

I notify that there is a gateway in the network 10.10.136.0 to permit my server to comunicate with the other network differents of the network 10.6.0.0 and network 10.10.136.0

regards
 

10 More Discussions You Might Find Interesting

1. Programming

determine if a ethernet interface is up

Howto check if a ethernet interface is up? It's impossible to determine via the ipaddress i have learned, or? Can someone please give me a hint on howto do? Environment == Linux x86 GNU GCC. :D regards Esaia (2 Replies)
Discussion started by: Esaia
2 Replies

2. SCO

Issue with a ethernet card

Installed a replacement 3com pci card on an ibm PC 300 GL, running OpenServer 6.0 , brought up system, and recieved this message: Fsstat:/dev/boot mounted Mounted /stand filesystem System auditing is not enabled. Dlpid:Unable to open network adapter driver (/dev/mdi/r8e0) Dlpid:No such... (0 Replies)
Discussion started by: tazmss1
0 Replies

3. Solaris

Network Interface Issue

Hi all, Here im facing problem with NIC Interface with my X86 Version of Solaris Express, even after loading module for that Interface. So please check this below mentioned log for your use and get back to me ASAP. - - - -- --... (0 Replies)
Discussion started by: baraghun
0 Replies

4. Solaris

Ethernet card drivers issue...

I need to install ethernet card drivers on intel machine. How can i know which Ethernet card interface (sfe,rh,rtls...) is it? How can i know the speed of that card? How can i know network traffic ? If network traffic is more with that interface what should i do? Thanks in advance (2 Replies)
Discussion started by: younus_syed
2 Replies

5. Solaris

Network interface issue

Hi All, I want to configure network into my system. i tried following in to configure the interface to find the name of interface #prtdiag |grep net i got following 0 PCI-1 33 1 network-SUNW, hme then i tried following #prtconf -v |grep net network, instance #0 (6 Replies)
Discussion started by: kumarmani
6 Replies

6. Solaris

Sun Solaris ethernet interface

Hi, During the installation of solaris suppose I am configuring one ethernet interface that is primary but on my server there are 4 ethernet interfaces,because all other interface not configured, what is way to find out how many ethernet interfaces are there on Server, (6 Replies)
Discussion started by: manoj.solaris
6 Replies

7. IP Networking

Need a bridge from an ethernet interface to a serial interface

This is my situation DOS pc serial cable (sl0) Linux Pc eth1 192.168.0.10 <-------------------->192.168.0.2 <------------>192.168.0.1 (router) I connected the linux pc and the dos pc with a SLIP (serial line internet protocol), so they can communicate in the sl0 interface. ... (3 Replies)
Discussion started by: mghis
3 Replies

8. AIX

interface collisions on ethernet nic

Hi, is there any method to check the interface collisions on ethernet NIC in AIX. I know that in Solaris it's netstat -i but I've written that in AIX it doesn't show this. Thanks&regards, p (1 Reply)
Discussion started by: pitmod
1 Replies

9. IP Networking

Channel bonding Issue - Bond0 interface not getting up in on RHEL6

Hello, I am trying to set up Channel Bonding on a RHEL6 Virtual Box VM. I have 2 ethernet cards on the machine which are set up in Internal Network mode. I followed all the steps exactly as mentioned in the RHEL6 deployment Guide, but for some reason i think results are not correct. Here are my... (13 Replies)
Discussion started by: Rohit Bhanot
13 Replies

10. UNIX for Advanced & Expert Users

C program to detect duplicate ip address if any after assigning ip address to ethernet interface

Hi , Could someone let me know how to detect duplicate ip address after assigning ip address to ethernet interface using c program (3 Replies)
Discussion started by: Gopi Krishna P
3 Replies
netmasks(4)							   File Formats 						       netmasks(4)

NAME
netmasks - network mask database SYNOPSIS
/etc/inet/netmasks /etc/netmasks DESCRIPTION
The netmasks file contains network masks used to implement IP subnetting. It supports both standard subnetting as specified in RFC-950 and variable length subnetting as specified in RFC-1519. When using standard subnetting there should be a single line for each network that is subnetted in this file with the network number, any number of SPACE or TAB characters, and the network mask to use on that network. Network numbers and masks may be specified in the conventional IP `.' (dot) notation (like IP host addresses, but with zeroes for the host part). For example, 128.32.0.0 255.255.255.0 can be used to specify that the Class B network 128.32.0.0 should have eight bits of subnet field and eight bits of host field, in addition to the standard sixteen bits in the network field. When using variable length subnetting, the format is identical. However, there should be a line for each subnet with the first field being the subnet and the second field being the netmask that applies to that subnet. The users of the database, such as ifconfig(1M), perform a lookup to find the longest possible matching mask. It is possible to combine the RFC-950 and RFC-1519 form of subnet masks in the net- masks file. For example, 128.32.0.0 255.255.255.0 128.32.27.0 255.255.255.240 128.32.27.16 255.255.255.240 128.32.27.32 255.255.255.240 128.32.27.48 255.255.255.240 128.32.27.64 255.255.255.240 128.32.27.80 255.255.255.240 128.32.27.96 255.255.255.240 128.32.27.112 255.255.255.240 128.32.27.128 255.255.255.240 128.32.27.144 255.255.255.240 128.32.27.160 255.255.255.240 128.32.27.176 255.255.255.240 128.32.27.192 255.255.255.240 128.32.27.208 255.255.255.240 128.32.27.224 255.255.255.240 128.32.27.240 255.255.255.240 128.32.64.0 255.255.255.192 can be used to specify different netmasks in different parts of the 128.32.0.0 Class B network number. Addresses 128.32.27.0 through 128.32.27.255 have a subnet mask with 28 bits in the combined network and subnet fields (often referred to as the subnet field) and 4 bits in the host field. Furthermore, addresses 128.32.64.0 through 128.32.64.63 have a 26 bits in the subnet field. Finally, all other addresses in the range 128.32.0.0 through 128.32.255.255 have a 24 bit subnet field. Invalid entries are ignored. SEE ALSO
ifconfig(1M), inet(7P) Postel, Jon, and Mogul, Jeff, Internet Standard Subnetting Procedure, RFC 950, Network Information Center, SRI International, Menlo Park, Calif., August 1985. V. Fuller, T. Li, J. Yu, K. Varadhan, Classless Inter-Domain Routing (CIDR): an Address Assignment and Aggregation Strategy, RFC 1519, Network Information Center, SRI International, Menlo Park, Calif., September 1993. T. Pummill, B. Manning, Variable Length Subnet Table For IPv4, RFC 1878, Network Information Center, SRI International, Menlo Park, Calif., December 1995. NOTES
/etc/inet/netmasks is the official SVr4 name of the netmasks file. The symbolic link /etc/netmasks exists for BSD compatibility. SunOS 5.10 7 Jan 1997 netmasks(4)
All times are GMT -4. The time now is 07:27 PM.
Unix & Linux Forums Content Copyright 1993-2022. All Rights Reserved.
Privacy Policy